The short answer
Not if it is leaking. Water that keeps entering can wet insulation and timbers through the whole winter, so a known leak is better dealt with now, with a temporary make-safe if permanent work needs better conditions. A dry, cosmetic fault, such as moss on a covering that still sheds water, can be planned for spring.
Why a known leak should not sit
Water that gets past the covering does not stay at the surface. It can run along rafters and battens, soak the insulation laid across the loft floor and reach the ceiling below. Wet insulation may lose much of its ability to hold heat, and timbers that stay damp for weeks can start to decay. A leak left through a whole winter is a far longer exposure than the same leak left for a week in July.
Cold weather adds its own part. Frozen water expands, so ice in a joint or a hairline crack can prise it wider, and the next thaw lets more in. A fault that began small can grow without anyone touching the roof.
None of this means every fault is an emergency. A leak is a fault that is actively letting water in. A stained tile or a patch of moss is different, because the covering is still doing its job. Our guide to the signs of a leaking roof sets out what points to water entry and what does not.
If water is coming in now, begin by limiting the harm indoors: move belongings away, stand a bucket under a drip and take pictures of the stain. The page on what to do if your roof is leaking goes through the steps in order.
Faults that can wait for spring
Some faults can be assessed and planned rather than rushed. What they share is a roof that is still keeping the water out, though which group a particular fault belongs to is something only a survey of the roof can settle.
- Moss or lichen on a covering that is still shedding water and shows no stain below.
- A chipped tile or an edge crack where the loft underneath stays dry after rain.
- A gutter that drains but wants replacing, with no overflow onto the wall.
- A cosmetic crack in the mortar at a ridge, with no tile moving.
- A planned replacement that is driven by age rather than by a fault.
A dry loft after heavy rain is a useful sign for the first three, and it costs nothing to check. Take a torch up, shine it along the rafters and the insulation near the eaves and around any chimney, and look for damp patches or drips. If the loft shows something you cannot place, a picture of it is enough to start with.
The reverse also holds. A slipped tile can expose the layer beneath it, so a fault that looks minor from the ground is worth a closer look before it is put on the spring list.
What a make-safe does in the meantime
A make-safe holds a roof watertight for a short time until permanent work can be done. It may be a sheet fixed over a damaged slope or a loose tile re-seated, and it is a holding step, not a finished repair. Our page on making a roof safe in an emergency explains how one works.
A make-safe exists because some permanent work wants dry, settled conditions, such as bedding in mortar or laying a membrane. When the forecast is poor, holding the roof watertight and returning for the permanent repair when conditions allow can be sensible, and it stops a leak running on for weeks.
Published ranges give a sense of scale. MyJobQuote's page dated 22 October 2026 gives typically £150 to £300 for an emergency roofer's call-out, and adds that extensive storm damage repairs can cost £1,200 or more. Which? Trusted Traders price a one-to-six tile replacement, at £75 to £400, excluding VAT (November 2025).
After the survey, the roof is priced as a single written total. For the full range of repair work, see our roof repairs page.

