Call 01582 935272

Roof repairs

Why is there water in my loft?

Wet timber, damp insulation or drips in the loft have three possible sources: a leak above, condensation, or eaves that cannot breathe. Each one leaves its own clues.

Get a written quote

Call 01582 935272WhatsApp us

Inside a loft room with a roof window letting in soft daylight
PicturedInside a loft room with a roof window letting in soft daylight.

The short answer

Water in a loft comes from a leak in the roof covering or a flashing, from condensation where warm damp air meets cold roof timbers, or from blocked eaves that stop air moving. A leak leaves wet patches below a fault and follows rain. Condensation shows as droplets and mould across a wide area, in cold weather.

A roof drawing with its parts named: daylight, damp stain, purlin, loft hatchDaylightDamp stainPurlinLoft hatch

Three ways water gets into a loft

A loft is the space between the ceilings and the roof covering, and water reaches it in three distinct ways. A leak lets rain past the tiles, slates or flashings. Condensation forms when moist air from the rooms below rises and meets the cold underside of the roof. Blocked eaves stop the air moving, so the damp lingers where it would otherwise be carried off by a draught. Telling them apart saves paying for a repair that does not address the cause.

Loft water: leak or condensation
ClueLeakCondensation
TimingDuring or after rainCold spells, rain or not
PatternPatch below one faultDroplets over a wide area
LookDark stain, drip pathBeads on nails, mould specks

The two can overlap. A roof can leak and also suffer condensation, so a single dry visit does not settle it. Noting the weather on each day that the loft looks wet is the quickest way to separate the causes, and a note of the room temperature below adds to the picture. Keep the notes with the dated photographs. A hygrometer from a hardware shop, left in the loft for a week, adds a reading to the notes. Record the readings in a small notebook that stays by the hatch, so the pattern builds up across a few weeks of mixed weather.

Leaks above the rafters

A leak shows as a stain, a drip or damp insulation under a particular point on the roof. A torch beam can pick out dark patches on the timber, chinks of light between tiles, and water marks around the chimney breast or a roof window. A mark on the underlay beside a rafter can show the route the water is taking. Photographs taken at the same spot on different days show whether the patch is spreading.

Slipped tiles, cracked slates, lifted flashings, worn valleys and loosened ridge tiles are all possible entry points. The page on signs of a leaking roof lists what each fault looks like from inside. Since water can run down a rafter before it falls, the dampest spot in the loft may sit lower than the gap that lets it in.

Stepping between the joists is dangerous, because the ceiling boards beneath will not take a person's weight. Looking in through the hatch, torch in one hand and phone in the other, is enough for a householder, and a photo sent to 07880 284133 on WhatsApp lets us study the position. Where wet insulation hides the fault, the survey has to look more closely.

Condensation and eaves ventilation

Warm air carries moisture from cooking, washing and breathing. Where it escapes into a cold loft, moisture settles on cold surfaces such as the underside of the covering, and in the right conditions it drips. Quilt stuffed tight into the eaves can block the gap where fresh air should enter, which leaves damp air with nowhere to go.

Where a cold roof is fitted with a high-resistance underlay, Marley's BS 5250 guidance gives eaves ventilation of 25 mm at a pitch of 15° or less, and 10 mm above 15°. That underlay is not vapour-permeable. A roof with a different underlay or a well-sealed ceiling follows different guidance, and those figures cover the first setup only, so a survey reads the roof before any vent is added.

Condensation is a ventilation and moisture problem rather than a leak, though a roofer can check the eaves and the underlay. Drying and ventilating the rooms below helps, and so does keeping insulation clear of the eaves. Where a roof needs more than that, the roof repairs hub sets out the repair options, and the page on how to find a roof leak helps you tell a leak from damp air.

Loft water, asked plainly

01Is water in the loft always a roof leak?

No. Condensation can leave droplets beneath the covering and wet the insulation without any water entering from outside. A leak follows rain and sits below a fault, while condensation spreads across a wide area in cold weather. Some lofts have both, which is why a survey checks the roof and the ventilation together. Dated photographs help to show which it is.

02Is wet insulation still any use?

Wet insulation can lose much of its effect and may hold moisture against the timbers. If a leak has soaked it, it may need replacing once the roof is repaired and the area has dried. Whether it can stay is a judgement made on the spot, from the condition of the material, not from a description over the phone. Checking it is worth doing once the roof is dry.

03Should I go into the loft to look?

Looking from the hatch is reasonable if you take a torch and stay on the ladder or a safe landing. Stepping between joists is not, because the ceiling will not carry you, and a roof space can hold insulation, wiring and old fixings that cause injury. The roof itself is left to people who have proper access. A phone camera held through the hatch can be reached from the ladder.

04Can blocked eaves cause water in the loft?

They can contribute. If insulation or debris blocks the air gap at the eaves, damp air stays in the loft and settles on cold timber. A leak is a separate fault, and the two can sit side by side. Clearing the eaves is a simple step, and the page on storm damage and insurance covers claims if the damage is storm related.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote