Call 01582 935272

Emergency roof repairs

Should I turn off the electrics if the roof leaks?

Water coming through a ceiling can reach wiring, light fittings and sockets, so the electrics need thinking about at the same time as the bucket.

Get a written quote

Call 01582 935272WhatsApp us

A gutter full of leaves, moss and a broken tile after a storm
PicturedA gutter full of leaves, moss and a broken tile after a storm.

The short answer

Switch off the power to the affected circuit at the consumer unit, but only if you can reach it without stepping through water or touching anything wet. If water is near lights, sockets or appliances and the unit is not safe to reach, stay clear and call an electrician. Do not turn the power back on until an electrician has checked.

A roof drawing with its parts named: tarpaulin, battens, missing tiles, ladderTarpaulinBattensMissing tilesLadder

When the consumer unit is the right first move

Water that has soaked into a ceiling can reach the cable running above it and the fittings screwed into it. A dripping light fitting, a stained ceiling rose or a socket on a wet wall are the points of concern, because a wet fitting can carry current into the water around it. If any of these sits in the path of the leak, isolating the circuit at the consumer unit, the box of switches or fuses, removes the supply to that part of the house.

The condition is that you can do it safely. Reach the unit over a dry floor, with dry hands, and without leaning on a wet wall or stepping through a puddle. Switch off the circuit that feeds the wet area, or the main switch if you cannot tell which circuit that is. If the unit is in a cupboard directly under the leak, or the floor in front of it is wet, do not go near it.

Switching off is a holding measure, not a repair. Leave the circuit off and tell an electrician what has happened. The wider picture of making a leaking roof safe sits on the emergency roof repairs hub, which covers what happens on the roof while the inside of the house is dealt with.

What to leave alone

Some things should stay exactly as they are while water is still coming in. Work through this list:

  • Do not operate a light switch or socket that is wet or sits under a stain.
  • Do not use a wet appliance, or an extension lead lying on a damp floor.
  • Do not poke at a ceiling light fitting that is holding water behind it.
  • Do not mop or vacuum around a fitting that may still be live.
  • Do not go up a ladder or into the loft to look for the source.

Lights that flicker, a burning smell, a buzzing or crackling from a fitting, or a breaker that trips and will not reset are signs of a fault. Leave the circuit off, keep everyone away from that part of the room and ring an electrician. If there is smoke or fire, leave the house and call 999.

A ceiling that sags under trapped water is a separate risk from the electrics, because the weight above can bring plasterboard down. The page on what to do when a ceiling is bulging deals with that side of it.

Getting the power back on

An electrician checks wiring and fittings before the supply returns to a circuit that has been wet. A ceiling can look dry while the cable above it is still damp, and a switch that clicks as it should can still be unsafe. Keep the circuit isolated until someone qualified has tested it and says it can be used again.

The roof needs attention in parallel. Stopping the water at source is a roofing job, and a temporary cover, described on the temporary roof covers page, can limit what gets in while the permanent repair is planned. Water that keeps arriving keeps soaking the same ceiling and the same cable, so the roof repair and the electrician's check go ahead side by side.

Photograph the wet ceiling, the fittings and the room before anything is dried, replaced or thrown away, because the insurer may want to see how the damage looked. Keep any receipts from the electrician as well, and write down the date you first noticed water near the fittings.

A picture of the stain and of the outside of the roof, sent to 07880 284133 on WhatsApp, gives us something to look at on the roofing side. The quote form on this page and info@daylightroofingdunstable.co.uk reach the same people.

Leaks and electrics, answered

01Can water from a roof leak cause an electrical fire?

Water on wiring can cause a short circuit, and a short circuit can cause heat damage. How likely that is depends on the wiring and on where the water lands, which is why the cautious response is to isolate the affected circuit if it can be reached safely, and to have it tested before it is used again. Smoke or a burning smell means leaving the house and calling 999.

02What if the consumer unit is in the wet area?

Do not go near it. Standing in water while touching a switch is exactly the situation to avoid. Keep people out of the area and ring an electrician. If the supply cannot be isolated, your local electricity network operator is the next call. Say clearly that water is near the unit, so the person on the phone understands the risk before they ask anything else.

03Is it safe to use the lights in other rooms?

Circuits feeding dry rooms may be separate from the wet one, so rooms away from the leak may be unaffected. Where you cannot tell which circuit feeds the wet area, switching off at the main switch is the cautious choice until an electrician has looked. A torch is a better companion than a lamp plugged in through a wet room while you wait.

04Who checks the electrics after a roof leak?

Testing wiring and fittings is an electrician's work. A roofer deals with the roof covering and the point where the water entered. Both jobs matter, and the roof repair is easier to plan once the inside of the house is safe and the damage has been photographed. Tell the electrician where the water came in, so they know which cables and fittings to look at.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote