Call 01582 935272

Guttering, soffits & fascias

What fall should a gutter have?

Brett Martin, a maker of guttering, gives the fall as 1 mm for every 600 mm towards the outlet. That slight slope is what sends rainwater to the downpipe instead of leaving it standing.

Get a written quote

Call 01582 935272WhatsApp us

A gutter full of moss and debris below a tiled roof
PicturedA gutter full of moss and debris below a tiled roof.

The short answer

A gutter should slope downward towards its outlet, and Brett Martin gives that fall as 1 mm for every 600 mm. The slope is slight, so the eye can miss it. Water that cannot run to the outlet stands in the gutter and can spill over the front edge.

A roof drawing with its parts named: gutter, fascia, soffit, underlay, rafterGutterFasciaSoffitUnderlayRafter

What a fall of 1 mm in 600 mm looks like

A gutter is not laid flat. It is set to slope gently along its length towards the point where water leaves it, the outlet, which feeds the downpipe. Brett Martin says guttering "should be installed with a downward fall" and sets the slope at 1 mm for every 600 mm, towards the outlet. That is Brett Martin's figure for its own guttering, so for a gutter from another maker, check that maker's fitting instructions.

The slope is hard to picture, so the arithmetic helps. A run of 6 metres is 6,000 mm long, which is ten lengths of 600 mm, so the far end sits 10 mm lower than the near end. That is a drop smaller than a finger's width, spread across the whole of a room-sized stretch of roof edge. A long straight run can look right from the pavement and still be wrong, and a run that looks tilted from the ground may be perfectly sound.

With the outlet at one end, the gutter tilts in a single direction. With it partway along, the gutter drops towards it from both sides. Either way the outlet is the lowest point, and every metre of gutter should be higher than the metre next to it on the outlet side. The fascia board behind carries the brackets, so the board has to be straight and sound for the slope to hold.

How a wrong fall shows itself

A gutter can lose its slope without any single dramatic fault. Brackets may sag when the fascia softens or a fixing works loose. A joint may be pushed out of line by a careless ladder. A gutter that was hung level in the first place will never drain fully, because nothing tilts the water towards the outlet. A run may also have been right at the start and then moved, if a stretch of the board behind it has dropped.

  • Water standing in the gutter after the rain has stopped.
  • Green staining or moss along one stretch of the run.
  • A drip stain or darker line on the wall below a particular point.
  • A visible sag between two brackets.
  • Water spilling over the front lip at one spot while the rest stays dry.
  • Silt, leaves or small plants gathered in the same place each time.

A puddle that stays once the rain has gone is the clearest pointer to a wrong fall, because water on a correct fall runs out. Debris gathers where water slows, so a stretch that fills up with silt again and again can point to a dip. A dip is not always a fall error, since a blocked outlet has the same effect on the water. Both are possible, which is why the cause is found before a fix is chosen. The signs your gutters need work guide lists the other things worth watching for.

Putting the slope right

Correcting a fall means moving the gutter, not the water. Brackets are unscrewed and refixed at the right heights, a string line or a level is used to set the slope, and the outlet is checked to be the lowest point on the run. Where the fascia has rotted, the brackets have nothing sound to hold, so the board is dealt with first. The fascia board page explains the part that carries the gutter.

Some runs cannot be corrected by adjusting brackets alone, for example where the roof edge itself dips or the board behind has moved out of line. Then the choice is between repair and replacement, which the repair or replace guttering page sets out. A job of this kind is quoted as one total after the survey. Scaffolding over a public footway needs a Highways Act 1980 s169 licence; we arrange the licence with our scaffolder.

A clean gutter and a correct fall are separate matters. Clearing silt from a run that is sloped wrongly leaves the same pool in the next shower, and a gutter that is sloped well still spills if the outlet is blocked. The guttering, soffits and fascias hub shows how the pieces fit together, so you can tell which one is causing the trouble before anyone climbs a ladder.

Gutter slope, answered in detail

01Is 1 mm in 600 mm the same as a 1 in 600 slope?

Yes. A drop of 1 mm over a horizontal run of 600 mm is a slope of 1 in 600. It is much shallower than the fall used on the roof itself. Because it is so slight, a gutter set to it looks level to a casual glance, so a wrong fall hides from view and shows itself only once water is running.

02How can I check a gutter's slope during rain?

Watch the run while rain is falling, or after it has stopped. Water that runs steadily towards the outlet suggests the slope is working. Water that pools along one stretch, or tips over the front edge at one point, suggests a dip or a blockage there. From a safe position on the ground, binoculars can help. A ladder never belongs against the gutter itself.

03Does a flat roof's internal gutter use the same fall?

No, it follows a different rule. NFRC says BS 6229:2025 sets "a minimum 1:80 finished fall for general roof areas and internal gutters" on flat roofs with flexible waterproof membranes. That standard is for the roof covering and its built-in drainage. The 1 mm in 600 mm figure from Brett Martin is for rainwater guttering hung along a pitched roof's eaves.

04Can a gutter with a poor fall be corrected without replacing it?

Sometimes. If the run itself is sound and the problem is sagging brackets or a loose fixing, refixing the brackets at the right heights can restore the slope. If the board behind it has rotted, or the gutter has cracked, refixing alone would not hold. What is found at the roof edge settles it. A gutter that holds a fall for a while and then loses it points to a fixing or a board that is still moving, and refixing the brackets without dealing with that cause would only repeat the problem a season or two later.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote