The short answer
A three-bedroom semi with a 65m² roof and plain concrete tiles may cost between £10,000 and £15,000, according to HomeBuilding, and Welsh slate might reach £18,000. Which? Trusted Traders give £7,000 to £21,000 for an average three-bedroom house, excluding VAT. A survey of your own roof settles the real total.
What the guides say about a semi
Guides to roofing prices lean on the three-bedroom semi because it is a familiar shape, and that makes comparison easy. It also makes it easy to mix figures that were never built the same way. The table keeps each one apart, with the basis printed next to it.
| Source | Figure | Basis |
|---|---|---|
| HomeBuilding | May cost £10,000 to £15,000 | Semi, 65m² roof, plain concrete tiles |
| HomeBuilding | Might reach £18,000 | Same property, Welsh slate |
| Which? | £7,000 to £21,000 | Average three-bedroom house, excluding VAT |
HomeBuilding's page was last updated on 30 September 2025. The Which? range comes from a survey of 11 Which? Trusted Traders in November 2025, and each price takes in labour and materials but not VAT. MyJobQuote, on a page dated 3 November 2026, gives an average for a new roof across the UK of around £5,250, a figure not tied to any house type.
Treat each one as a marker for scale. None of them is an amount to expect, and none should be added to another to make a bigger range. A gap of several thousand pounds between two guides is normal when the roof, the covering and the year are not the same. Read the date on any figure as well, because prices published a year apart are not like for like.
What shifts the total on your semi
The 65m² in HomeBuilding's example is one roof area. A different pitch, a longer footprint or an extension roof changes it, and a roof is priced on what is actually there. A firm has to see it before it can put a number on paper.
- The covering. HomeBuilding shows a gap between plain concrete tiles and Welsh slate on one house.
- The shape. Hips, valleys, dormers and a bay roof all add cutting and flashing.
- The party wall. A semi shares one side with its neighbour, so the roof edge and any shared chimney stack need careful detail.
- Access. Where the job needs scaffold at the front and back, it sits inside the written quote.
- The timber below. Battens and boards that have rotted are found when the old covering comes off.
Weight matters too. A new covering 15 per cent or more heavier than the old one needs Building Regulations approval, and the Planning Portal says a structural engineer or surveyor should be consulted before the work begins. Re-roofing a whole house goes past the Portal's limit of less than 50 per cent of the roof, so approval applies there as well. The Building Regulations and Part L page covers the route.
Getting a price for one house
Published ranges tell you whether a quote lands in a believable area. They cannot replace a survey, because no guide has seen your slopes, your chimney or the state of the timber under the tiles. After a survey we give you one total price in writing for the work as described.
When you hold two or more quotes, check that each describes the same slopes, the same covering and the same extras around the chimney, the ridge and the fascias. A low total can mean part of the roof was left out. Put the same question to each firm about what its total takes in, and read the description before the number.
If the roof is near the close of its working life, you may be weighing a repair against a full replacement. The signs you need a new roof page sets out what can be seen from the loft hatch and from the pavement.
The wider picture sits on the roof replacement page, and the new roof costs page covers how the sources compare. To start, call 01582 935272, or message us on WhatsApp on 07880 284133 with a clear photo of the roof taken from the ground.

