The short answer
Yes, roof windows can be fitted in winter, provided the weather allows the opening in the slope to be made watertight again before the work stops for the day. Rain, strong wind and hard frost can all hold a job back, and a temporary cover can protect the room while the unit is changed.
What weather does to an open slope
Fitting or swapping a roof window means lifting part of the covering and leaving a hole in the slope while the old unit comes out and the new one goes in. The weather during that stretch of work therefore matters more than the month on the calendar. A dry, calm, frost-free winter day can suit the job, while a wet or blustery day in any season may not.
| Condition | Effect on the work |
|---|---|
| Rain | Water reaches the lining, insulation and ceiling through an open slope |
| Strong wind | Units and sheets of covering catch the air at height |
| Hard frost | Sealants and adhesives may fall outside the maker's stated range |
| Short daylight | Fewer working hours to leave the slope watertight |
Sealants, adhesives and flashing foams carry temperature ranges in the maker's instructions, and a product used outside its range may not set or bond as intended. A job planned for a cold week follows those limits as well as the forecast.
A watertight slope by the end of each working day is the sensible target, with either the unit set and flashed or the opening closed under a temporary cover. Daylight in winter is short, so the opening is better made on a day when the whole sequence fits.
A swap and a new opening
A like-for-like swap is the more forgiving winter job. The opening, the frame position and the battens around it already exist, so the work is confined to the unit, its flashing and the lining. MyJobQuote, in its Velux window cost guide dated 22 September 2026, says a replacement costs "around £100 less for a straightforward swap, as the opening is already in place".
A new opening is a bigger undertaking. Rafters are cut and trimmed, the roof is open for longer and the structural change goes before building control. Those steps give a new opening more reason to wait for settled weather than a swap has.
The specification does not change with the season. Approved Document L 2021 gives 1.4 W/m²K for a replacement roof window with a separate, higher figure of 2.2 W/m²K for a rooflight. The names mark different installations: a rooflight stands proud of the slope on a raised frame, while a roof window lies flush in the slope. A unit ordered for winter fitting is checked against whichever figure fits it.
Cold weather also raises a question about what lies behind the unit. Insulation and the lining around the frame are fitted so that warm indoor air does not reach the cold edge of the frame. A winter fitting is a fair moment to look at that detail, and the page on condensation on roof windows explains why it matters.
Settling the job before a date
Begin with the kind of job: a swap, or a new opening. Photographs of the existing unit and of the ceiling beneath it can go to WhatsApp on 07880 284133, where they get looked at. A survey then gives the price, as a single written total. Where the roof is awkward to reach or the unit is an unusual size, a photograph helps to spot that early, and it saves a wasted visit when a different approach is needed.
Look around the current unit before the weather turns. Staining on the lining, damp reveals or a frame that no longer closes tightly are all worth noticing. The repair or replace comparison helps with the choice between mending a unit and changing it. A pane that mists in cold weather is a different matter, and the same page deals with it.
Winter also brings the indoor side of the problem: a cold pane meeting warm damp air can mist, and a new unit does not cure a room that is badly ventilated. The main skylights and roof windows page covers the flashing, lining and other work close to a unit.

