The short answer
A roof window flashing kit is the set of collar pieces that seals a roof window into the tiles or slates around it, carrying rain from the window frame out onto the covering below. The kit is matched to the profile of the covering, so a kit made for one roof covering can be the wrong one for another.
What the kit is and what it does
Because a roof window lies flush with the slope, everything the slope above sheds runs straight at its frame. A bare joint between frame and covering would not stop that water. The flashing kit does the stopping. It is a set of formed pieces that wrap round the frame and lap over or under the tiles or slates, so that rain reaching the window is turned aside and sent over the covering below instead of past the frame.
A kit is made in sections because each edge of the window has its own task. The head, the sides and the sill each take their own piece.
| Edge | Job of the flashing |
|---|---|
| Head, at the top | Turns water running down the slope round the frame |
| Sides | Overlaps the covering so water cannot creep in at the edge |
| Sill, at the bottom | Lets water leave the window and land on the covering below |
Maker's names for the pieces differ, so the table describes the work each piece does and not any product's label. The pieces are metal or a similar formed material, supplied with the fixings and the sealing strips that go with them. Velux is a brand of roof window, and a maker's kits are made for that maker's own units, while other makers sell their own windows with their own flashings.
Why the kit has to match the covering
Tiles and slates are not all the same shape. A slate lies flat, a plain tile has a gentle curve and a profiled tile has deep waves, and the flashing has to follow whichever one surrounds the window. A kit made for a deep profile will not seal against flat slates, and the reverse is also true. For that reason kits are sold in versions for different coverings, as well as for different window sizes.
A kit is chosen from two facts: the model of the window and the type of covering around it. If either is wrong, gaps can open at the edges. That is easy to miss on the day, because a gap at the side of a frame may not leak until the weather turns heavy.
The same two facts matter when a window is replaced. A new unit of another model, or a covering that was changed after the last window went in, can leave the old kit unsuitable. The kit is not assumed to be reusable. The covering around the opening is lifted, the battens and underlay are looked at, and a kit that fits the new unit and the covering is fitted, with any cracked tile or slate replaced. If you would like a first view of what is on your roof, a photo sent to WhatsApp on 07880 284133 can be looked at.
When a kit lets water in, and what to check
A kit can let water in for several reasons. The sealing strips can age and shrink. A piece can be knocked out of position, or a tile beside it can crack. The wrong kit for the covering leaves gaps from the start. From inside, the signs are a mark in one corner of the window lining, damp on the ceiling beneath the sill, or timber round the frame that has gone soft. The page on signs a roof window needs replacing goes through what the inside of the room shows.
A stain does not point to the kit alone. A cracked pane, a worn seal on the opening sash or condensation on cold glass can all look similar. The survey looks at the flashing, the covering around it and the frame, and then says plainly what it found. The guide to repairing or replacing a roof window sets out when a new kit is enough and when the window goes too.
A replacement unit has to meet Approved Document L, and Table 4.2 gives a roof window 1.4 or Window Energy Rating Band B minimum. The flashing kit is separate from that rating. For the full range of window work, see the skylights and roof windows hub.

