Call 01582 935272

Commercial roofing

Can solar panels go on a commercial roof?

Panels suit some commercial roofs and not others. The structure under them, the state of the covering and the route for access settle the question long before a panel is ordered.

Get a written quote

Call 01582 935272WhatsApp us

A large commercial single-ply roof with rooflights and plant
PicturedA large commercial single-ply roof with rooflights and plant.

The short answer

Yes, solar panels can go on a commercial roof when the structure can carry them, the covering is sound enough to stay under them for years and safe access exists. The council's planning and building control teams should be asked before any fixing starts, since the answer varies by building.

A roof drawing with its parts named: rooflights, roller shutter, gutterRooflightsRoller shutterGutter

The roof comes before the panels

A panel array adds weight, wind load and a lot of fixing points to a roof that was designed for something lighter. Whether the structure can take that is a question for a structural engineer, and a roofer cannot answer it by looking at the deck. Purlins, rafters, steel frames and the deck sheets each carry part of the load, and the way the roof was assembled can limit where brackets are allowed to go.

The covering matters just as much. Once panels are bolted on, the membrane or sheets underneath are hard to reach, so a covering that is already tired becomes a problem you cannot easily see. HSE's guidance says that "AC roofs are always fragile", and the same body tells owners to assume asbestos is present wherever a building was "built or refurbished before 2000". Fixing through asbestos cement sheets is not routine roofing, and the question of what the roof is made of has to be settled before a drill is picked up.

Access completes the picture. Installers, and later anyone who inspects or cleans the array, need a safe way onto the roof and safe routes across it. Walkways, edge protection and clear zones around rooflights are part of the design, not afterthoughts. A roofer's survey can report on the covering, the laps, the rooflights and the edges, which gives the designer something firm to work from.

Fixings, falls and how long the covering lasts

Every bracket or ballast tray is a place where the roof can fail. On a sheeted roof, each fixing through the covering needs sealing and the sheet must be sound enough to hold it. On a flat membrane roof, ballast or brackets can sit across the falls and hold water back. NFRC reports that BS 6229:2025 sets a minimum 1:80 finished fall for general roof areas and internal gutters. A flat roof that already ponds is worth correcting before panels cover it, because standing water around a bracket base tests the seal every day.

Panels also stay put for years, so the age of the covering matters. Sources disagree on how long flat roof coverings last, so both are shown.

Flat roof covering lifespans from two sources
CoveringHomeBuildingLess
EPDM25-30 years30 to 50 years
GRP25-30 years25 to 40 years
Felt10-15 years10 to 20 years

Less adds that felt lifespans depend "on quality and installation". If the covering is near the end of those ranges, lifting the array later to renew the roof is an extra job that a re-cover beforehand would avoid. Our guide to how long a commercial roof lasts sets out the ranges in more detail.

Council checks before work

Whether a given array needs planning permission depends on the building and its setting, so ask the council's planning team before assuming either way. Conservation areas, listed buildings and the shape of the proposal can all change the answer, and the planning team can say which of them applies to yours.

Building control is a separate check. In England it is carried out by the council's building control team or by a registered building control approver, and it covers structural safety as well as other matters. Ask which applies and what they need to see before the work starts, because the engineer's loading figures are likely to be part of that conversation.

Roofing and electrical work are separate trades. The roofer looks after the covering, any penetrations and the weatherproofing around them, while the electrical connection belongs to someone else. To raise the roof side, send a photo to WhatsApp on 07880 284133 and the roof can be surveyed before a written total is given. The commercial roofing page has the wider picture, and the commercial roofing regulations guide covers the rules that apply to work on business premises.

Panels on a business roof, asked and answered

01Can panels be fixed to an asbestos cement roof?

Treat it as a specialist question. HSE says AC roofs are always fragile, and drilling or cutting asbestos cement sheets disturbs the material. Before any panel layout is drawn, the roof should be assessed so that the sheets are identified and the right method chosen. A roof built or refurbished before 2000 is assumed to contain asbestos until shown otherwise.

02Should a commercial roof be repaired before panels go on?

Existing leaks, failed laps, damaged rooflights and ponding are all easier to deal with while the surface is clear. Once an array covers the roof, finding and fixing them means lifting panels. A survey before design shows whether repairs, a new covering or nothing at all is needed beforehand, so the roof does not have to be opened up later.

03Do panels make a flat roof harder to inspect?

They can. Ballast trays, frames and cable runs hide parts of the surface and can trap leaves and debris against upstands and outlets. A roof with panels on it should have walkways, gaps for access and a way to reach every outlet. Planning those routes at the design stage is far simpler than finding them afterwards, and it keeps later checks of the membrane possible.

04Does a solar installation on a commercial roof need planning permission?

Ask the council before assuming. The answer depends on the building, its setting and the proposed layout, and a conservation area or listed status can change it. Planning officers can say whether an application is required, and building control, either the council's own team or a registered building control approver, can say what the structure must show before work begins.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote