The short answer
A built-up felt roof is a flat roof covering of bitumen felt laid in layers over the deck, with a surface finish on top. It is not a single-ply membrane. Sources give its lifespan as 10 to 15 or 10 to 20 years, depending on who is asked and on the quality of the installation.
How a built-up felt roof goes together
The name describes the method. Instead of one sheet, a built-up felt roof is assembled from several layers of felt that are bonded to each other on the roof, so the waterproofing is built up in place. The felt itself is a reinforced base soaked in bitumen, and the layers are joined with hot bitumen, cold adhesive or a flame, depending on the system. Because the layers are bonded on the roof itself, the quality of the work on the day shapes the finished roof as much as the felt does, and the weather during laying matters to how well the layers bond.
- Deck: the structural surface that carries the roof, such as timber, concrete or profiled steel.
- Insulation and vapour control: boards and a barrier laid before the felt on a warm roof.
- Base layer: the first felt layer, bonded or fixed to what lies beneath.
- Cap sheet: the top felt layer, which takes the weather and sheds water to the outlets.
- Surface protection: chippings, paint or a mineral finish that shields the felt from sunlight.
Each joint between layers, and each detail at an upstand, pipe or rooflight, relies on how well it was sealed. The multiple layers give a second line of defence if the top layer is damaged, but they also mean that moisture trapped between layers is hard to see from above.
It is not single-ply, and how long it lasts
Single-ply means a single membrane, such as EPDM or TPO, that is rolled out and joined at its edges. Built-up felt has several layers of bitumen felt, so it belongs to a different family, and so does GRP, which is a resin and glass fibre system. Mixing the groups up leads to wrong expectations about repairs and lifespan. Our guide to single-ply membranes for commercial roofs covers the other family.
On lifespan, two sources give figures. HomeBuilding gives felt 10-15 years, and Less says "Torch-on felt lasts 10 to 20 years depending on quality and installation". The two ranges overlap but do not match, and neither describes a particular roof. A roof's remaining life turns on its laying, its upkeep and the weather it has had, and the survey looks at each.
Wear shows in recognisable ways: blisters where trapped moisture or air lifts the surface, splits and cracks at laps and upstands, exposed felt where chippings have washed away, and ponding where the falls are poor. Each of these is something a roofer can see on a visit, so a photograph of the problem area is a useful first step. Surface protection is worth a look as well, since felt left bare can break down under sunlight.
Repair, overlay or replace a felt roof
A local fault, such as a blister, a split lap or a failed flashing, can be cut out and patched. Where wear is widespread, the covering may be overlaid with a new layer, or stripped and replaced. The right choice depends on whether the layers beneath are sound and dry, so the survey looks beneath the surface, at the deck and the falls as well.
A replacement is also a chance to improve the roof. Insulation, falls and edge details can be corrected once the old covering has been stripped, and the new covering can be another felt system or a different type. For the broader question of when patching stops being sensible, see our guide to repairing or replacing a commercial roof.
If a felt roof is leaking or ageing, send photos by WhatsApp to 07880 284133, or ring 01582 935272. A survey of the roof comes ahead of any price, and what follows is one written sum. Read about the full range of work on the commercial roofing page, and see how long a commercial roof lasts for lifespans across other coverings.

