The short answer
It depends on the build. A cold flat roof, with insulation at ceiling level, needs a ventilated void above it so moisture can escape, while a warm flat roof, with insulation above the deck, has no void to ventilate. Condensation in a roof is a moisture problem, not always a leak.
Cold roofs, warm roofs and the void
Where the insulation goes decides the ventilation. The insulation in a cold roof runs between or just over the ceiling joists, with an air space left open above it so that air can pass through. That moving air carries away damp that gets past the insulation. The deck above the void stays cold, and that is how the design earns its name.
A warm roof does the reverse and puts the insulation on top of the deck, beneath the waterproof covering. Deck and joists stay at room temperature, and since no void is left under the covering, nothing needs ventilating. The design leans on a vapour control layer under the insulation, which stops moist indoor air from reaching it.
| Question | Cold roof | Warm roof |
|---|---|---|
| Insulation sits | At ceiling level | Above the deck |
| Void beneath covering | Yes, ventilated | No void |
| Ventilation needed | Yes | No |
Vents or gaps along the soffit or fascia suggest a cold roof, although a survey is the only sure way to know. The guide to warm and cold flat roof insulation looks at both builds in detail.
Where condensation comes from
Warm indoor air carries water vapour. It escapes upward through small gaps in a ceiling and around light fittings, and once it reaches a cold surface it condenses into liquid water. A cold roof's void is meant to flush that vapour out before it settles on the timber and insulation. Block the vents and the vapour stays where it is.
Two British Standards matter here. BS 5250:2021 is the BSI code on managing moisture in buildings, listed as current though under review. BS 6229:2025 is the BSI flat roof code, for continuously supported flexible waterproof coverings, which replaced the 2018 edition. One deals with moisture moving into the building fabric, the other with the covering that sheds rain.
Condensation can pass for a leak, but the pattern gives clues. Stains that appear in cold spells and fade in warmer ones, damp around ceiling edges, mould spots and drips on a dry day all point towards condensation. A stain that follows heavy rain points to water getting in from outside. A look in the loft or at the build-up, with a small inspection opening cut if needed, can separate the two, and the answer decides whether the cure is more ventilation, a sealed ceiling or a new membrane.
Insulation packed tight at the eaves can shut off the air path in a cold roof, so whoever fits new insulation has to keep that route clear.
What to ask before a roof is re-covered
Re-covering is the one moment when the build-up itself can change. Fitting new insulation above the deck turns a cold roof into a warm one, and that changes the ventilation answer altogether. Any such change falls within Part L, which treats a replacement membrane as renovation and expects an upgrade of the roof where that is feasible.
The change has to be done in the right order. A void left open beneath new insulation can undo its benefit, while a void sealed without a vapour control layer can trap moisture. Ask which type of roof you will end up with, and where the vapour control layer, the insulation and the deck sit in the finished build.
Ask also whether the existing insulation is dry. Damp insulation under a fresh covering can hold moisture against the deck for years. The flat roofing page lists the coverings on offer, and a photograph of a stained ceiling sent to WhatsApp on 07880 284133 gives the question somewhere to start. Whichever way the build goes, the roof is surveyed before anything else, and one written sum follows.

