The short answer
A bargeboard is the board fixed up the angled side of a gable roof, where the roof meets the end wall at the verge. It covers the timbers beneath the tiles and keeps weather off them. Unlike a fascia, it climbs the slope and carries no gutter, and a timber one can rot if water reaches the wood.
Where a bargeboard goes on the house
Find a house with a gable, the triangular end wall that rises to the ridge. The slanted roof edge that runs up that triangle is called the verge, and the board along it is the bargeboard. Some people call it a verge board. It is fixed to the timbers that project beyond the wall and hides their cut ends, so what you see from the street is a clean line instead of a row of bare timber.
A fascia and a bargeboard do the same kind of job in different places. The fascia runs level along the eaves, the lowest line of the roof, and holds the gutter. The bargeboard climbs the gable from eaves to ridge and holds no gutter. A roof with hips in place of gables meets the eaves differently, and has no bargeboard at those corners. The fascia board page covers the board beneath the gutter.
On a plain house a bargeboard is a flat board, painted or covered in white plastic. On some older houses it is shaped, with cut-out patterns along its lower edge, and it is part of how the house looks. A shaped board is harder to copy than a straight one, because each pattern has to be cut to suit the house, so a replacement can mean matching a design as well as fixing a board.
What it protects and how it is fixed
The reason for the board is protection. At a gable the roof covering stops, and without a cover the cut timber ends, and the top of the wall beneath them, would be left open to the weather. A bargeboard shields those ends from wind and rain, and it gives the verge its finished edge.
- It masks the cut ends of the timbers at the gable.
- It shields the top of the wall from wind and driven rain.
- It gives the verge a straight, finished line.
- It carries paint or a plastic cover that keeps weather off the wood.
- It can add character where the board is shaped.
How it is fixed varies. A timber board is nailed or screwed to the timbers behind it and painted. A plastic cover board can be fixed over a timber one, which stays in place beneath. The verge tiles have their own fixing, either mortar or a dry system under BS 8612:2018, which is current for dry-fixed verge as well as ridge and hip. The board sits outside all of that and forms part of the finished edge, but it is not what holds the tiles on.
Rot, damage and what to look for
A bargeboard is exposed on its face and on its lower edge. Water can reach the end grain at the cut ends, the joints between lengths and the top edge where the roof covering ends. Those are the places where timber can start to soften. Paint that has failed lets the wood take up water, and once it is wet it can swell, split and rot.
- Flaking or bubbling paint, along the lower edge in particular.
- Dark patches, or timber that is soft when pressed.
- Splits and open joints between lengths.
- A board that has bowed or is pulling away at the ridge end.
- Gaps along the top edge where water can get in.
A retailer selling uPVC roofline products says that its fascia boards can, when installed correctly, "typically maintain reliable performance for between 20 and 40 years". That is a seller's own figure for plastic, and it needs sound timber beneath. If a bargeboard has gone, the verge behind it may need a look too, because rot can reach the timbers it was covering. The how long fascias and soffits last guide gives the sources side by side, and the soffit page covers the panel under an overhang. All of these sit within the guttering, soffits and fascias hub.

