The short answer
A lead flat roof is a flat roof covered in rolled lead sheet, laid over a boarded deck and joined at timber rolls and drips. The lead is shaped by hand on site rather than welded or bonded. HomeBuilding gives lead on a flat roof 60-100 years, and Less gives 50 to 100.
How a lead flat roof is put together
A lead flat roof starts with the deck, which is a layer of boards fixed across the joists. The boards are laid to a fall, so rain runs off towards a gutter or an outlet. The lead then goes over them on a separating layer so the metal does not sit directly on the timber. The sheets run in strips from the low edge to the high edge.
Two details give the roof its look. Along the slope, the joints sit over rounded timber rolls, with the lead from each side dressed up and over to close the seam. Across the slope, the deck drops in small steps called drips, so one sheet can overlap the next and water spills over each step rather than pooling. Where the roof meets a wall, the lead turns up into an upstand, and a separate flashing covers the top of it.
Lead is a soft metal, so each sheet is fixed along its upper edge with clips that let the metal move as the weather warms and cools. Sheets that are fixed too hard to the deck can tear along the line of the fixings. That is one reason the specification, rather than the roofer's habit, sets how long each sheet runs and how it is held. This page stays with the flat roof itself; the wider range of work, from flashings to bay roofs, is on the lead roofing page.
How long sources say lead lasts
Two guides give lifespans for flat roof coverings, and they do not agree to the year. HomeBuilding's approximate lifespans were last updated on 30 September 2025. Less's flat roof cost guide was last updated on 12 November 2026. The table sets out both, and neither describes any one particular roof.
| Covering | HomeBuilding | Less |
|---|---|---|
| Lead | 60-100 years | 50 to 100 years |
| EPDM | 25-30 years | 30 to 50 years |
| GRP | 25-30 years | 25 to 40 years |
| Felt | 10-15 years | 10 to 20 years |
Less calls lead "the longest-lasting option" in its guide. Both ranges for lead are wide, and both sit above the ranges those guides give for the other coverings. A separate figure applies to lead flashing rather than to a whole roof: MyJobQuote says correctly installed lead flashing can last for over 80 years. That is a statement about flashing, so it is not carried over to the deck. How long any roof lasts also depends on the deck underneath it, so the boards and joists are checked before anything is said about the covering. The guide to how long lead flashing lasts goes into the flashing figure.
What the lead is measured against
Rolled lead sheet is made to BS EN 12588 in codes 3 to 8, and code 4, for example, is 1.80 mm thick. Each detail on the drawing carries its own code from the specification, so the main sheets can be one code and the upstands and flashings another. The codes are laid out in lead sheet codes explained.
A different standard is easy to confuse with this one. BS 6229:2025 is the up-to-date code for flat roofs using continuously supported flexible waterproof coverings. That wording describes membranes, and lead is not one, so the membrane falls quoted from that code are not lead roof figures. The roof still needs a fall, and the specification states the one this roof is built to.
Replacing a roof is also a Building Regulations matter. The Planning Portal's re-roofing page says: "In most situations, this work will need Building Regulations approval." The route for a particular flat roof, and any planning question where it sits in a conservation area, goes to the council's building control team, so check with the council before anything is ordered.

