Call 01582 935272

Pitched roofing

Can new tiles go on the old battens?

Sometimes the old battens can stay, but only when they are sound and spaced to suit the new tile. Both points are checked once the old covering is off, as the pitched roofing page explains.

Get a written quote

Call 01582 935272WhatsApp us

A stack of new clay plain tiles on a scaffold board
PicturedA stack of new clay plain tiles on a scaffold board.

The short answer

New tiles can go on old battens only when the battens are sound and set at the right spacing for the new tile. A different tile length or lap changes that spacing, and rotten, split or badly nailed battens are replaced. BS 5534 covers how slating and tiling is fixed.

A roof drawing with its parts named: daylight, damp stain, purlin, loft hatchDaylightDamp stainPurlinLoft hatch

What a batten does, and how it wears

A batten is a thin strip of timber nailed across the rafters over the underlay. Each course of tiles hangs from its batten by a nib on the back of the tile, and nails or clips add to that hold on the courses the specification calls for. The batten therefore carries the tiles and passes their load into the rafters.

Timber that has sat under a covering for a long time has had a hard life, and its condition varies a great deal from one roof to the next. Damp is the main threat. A cracked tile, a slipped slate or a worn underlay lets water onto a batten, and softened wood stops holding a nail. Old battens also carry rows of nail holes from the earlier covering, and each hole is a place where the wood can split when it is fixed again.

A check from the loft only shows the undersides. Once the covering is off, the top faces and the ends can be examined, which is where rot and splitting can show up. A batten that bends when pressed, crumbles at an end or has lost its nail grip is replaced.

Checking every batten matters more than checking a few, because a single weak lath beneath a course of tiles leaves that course badly supported.

The gauge has to suit the new tile

Gauge is the distance from one batten to the next, measured along the slope. It is not a free choice. It follows from the length of the tile and the lap, which is how far each course covers the one below. Change the tile and the gauge can change with it.

That is the heart of the old-batten question. Old battens were fixed at a gauge that suited the old tiles. Where the replacement is the same size and lap, the spacing may match. Where it is longer, shorter or laid to a different lap, the battens sit in the wrong places and have to be moved or replaced. The table sets out the cases.

Reusing battens for a different covering
SituationOld battens
Same tile, sound timberMay be refixed, with failed lengths replaced
Different tile length or lapSpacing is reset, which means new battens
Rot, splits or soft endsReplaced, whatever the tile
Underlay found failedBattens lifted to renew it

Spacing at the eaves and the ridge is worked out separately from the field of the roof, since the first and last courses have their own set-out. A survey of the roof shows how much of this applies.

Standards, cost and the decision

BS 5534:2014+A2:2018 is listed as current by BSI. Marley notes that installing to BS 5534 isn't required by law. The same maker adds that each roof's own fixing specification overrides the standard's baseline figures. Battens belong to that fixing system, so a lath that cannot hold its nails weakens the whole arrangement.

New battens add a little to the materials in a re-tile, but beside the tiles and the labour they are a small item, and refixing weak ones can cost more than replacing them. Whatever is found, the quote for the job is a single figure given after the survey, and the pitched roof costs guide covers what moves it.

  • Soundness: no rot, splits, soft ends or lost nail grip.
  • Section and spacing: set out to suit the chosen tile.
  • Underlay beneath: whole, lapped and not perished.
  • Fixings: nail type and pattern as the specification requires.

A whole-roof re-covering also meets Building Regulations: the Planning Portal's main page says that in most situations this work will need Building Regulations approval. The re-tiling and Building Regulations page gives the weight and area limits.

In practice the decision is simple. Look at the battens, match the gauge to the tile that has been chosen, and replace whatever fails either test.

Old battens, question by question

01Can I reuse battens that look fine from the loft?

The loft shows only the undersides, and the tops are where rot and splitting can hide. Battens are judged once the covering is stripped, when the timber can be pressed, sounded and checked at the ends. A batten that looks fine from inside but has lost its grip on a nail is still a weak support for the course above.

02What if the new tile is a different size?

Then the gauge changes, because it depends on the tile length and the lap. The old battens were fixed to suit the old tiles, so they are repositioned or replaced to give the new spacing. Putting a new tile onto battens set for a different one leaves the laps wrong and can let water in at the joints between courses.

03Is the underlay replaced when battens are renewed?

The underlay sits beneath the battens, so lifting them exposes it. If it has perished, torn or lost its laps, it can be renewed while the roof is open, and doing so costs little extra at that stage. If it is sound, it can stay. The condition of the underlay is part of what a survey of an old roof looks at, and the when to re-tile guide covers the signs.

04Is BS 5534 a legal requirement for the battens?

Marley states that installing to BS 5534 isn't required by law. The Building Regulations test for a re-roof is separate and looks at the extent of the re-covering. The standard still sits behind how tile fixings and battens are worked out, and a per-roof specification can override its baseline, so the batten check stays part of any careful re-tile. Ask for the batten findings in plain words.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote