The short answer
A breathable roof membrane is a vapour-permeable underlay laid under the tiles or slates. It keeps liquid water out of the roof void but lets water vapour from inside the house pass out through it. High-resistance underlay does not do that and is a different product, so the two should never be mixed up.
What the word breathable means here
Under the tiles of a pitched roof sits a second line of defence, the underlay. Its first job is to catch rain or snow that is driven past the covering, and to shed it towards the gutter. A breathable membrane has a second job as well. It is vapour-permeable, meaning the moisture that rises from kitchens, bathrooms and the people living in the house can pass through the sheet and escape, while liquid water cannot get in.
Two abbreviations turn up in the trade. LR means low resistance, which is the vapour-permeable kind sold as breathable. HR means high resistance, which describes the older style of underlay such as traditional bitumen felt. An HR underlay is not vapour-permeable. Calling it breathable is a mistake worth catching, because it changes how the roof void has to be ventilated.
Marley, the tile maker, also points out that air permeability belongs to the roof covering and not only to the underlay. So the choice is a decision about a whole build-up and never about one sheet. That is why the underlay is read together with the covering above it and the ceiling below it, and why a label on a roll tells you only part of the story.
Low resistance and high resistance, side by side
The difference shows up in how much ventilation the roof needs. Marley's guidance, drawn from BS 5250 on managing moisture in buildings, gives the contrast for a cold roof. That is a roof where the insulation sits at ceiling level and the void above stays cold.
| Underlay | Roof conditions | Eaves ventilation |
|---|---|---|
| High resistance | Pitch of 15° or less | 25 mm along the eaves |
| High resistance | Pitch above 15° | 10 mm along the eaves |
| Low resistance | Well-sealed ceiling, air-permeable covering | 3 mm from normal eaves construction |
For the low-resistance row, Marley says the ordinary gap left by normal eaves construction supplies all the ventilation needed, as long as the product's UKAS Third Party certification conditions are met in full. The conditions matter. A leaky ceiling, or a covering that does not let air through, changes the picture, so the row is no blanket permission to skip ventilation.
Two houses on the same street can differ here, since each has its own ceiling, loft and covering. What counts is the actual build-up above your own bedrooms. The pitched roof ventilation guide goes further into where air enters and leaves a roof void.
Choosing one, and what sets the price
The choice between a breathable membrane and a high-resistance underlay is settled for a single roof and never as a general rule. It depends on the covering, how well the ceiling below is sealed, whether the loft is lived in or left cold, and what ventilation the roof already has. Swapping an old underlay for a different type without looking at those points can leave moisture trapped in the roof void, so they are the things to establish before any quote is written.
Underlay is laid over the rafters as part of a re-tile, beneath the battens. When the covering is stripped, the old sheet is plainly visible, and torn or perished felt is renewed along with the tiles. A full re-roof also falls under Building Regulations, covered in the re-tiling and building regulations guide.
Underlay is a small part of a re-roof and is not priced on its own anywhere we can point to. What moves the total is how big the roof is, how hard it is to reach, the covering chosen and what is found once the old tiles are lifted. Daylight Roofing sends one price in writing when the survey is finished. A photo of the existing underlay from the loft can go to 07880 284133 on WhatsApp. The wider picture is under pitched roofing.

