The short answer
Mortar in a gutter means that mortar somewhere above is breaking up and washing down. Sources include the bedding under the ridge tiles, the hips and the gable verges, though a chimney stack can shed it too. A few crumbs may be old pointing, while steady grit points to bedding that is failing.
Where the mortar comes from
Mortar does not drop off a roof for no reason. Rain, frost and the movement of the roof wear it down, and when it crumbles the pieces slide towards the eaves and land in the gutter. A gutter holding grit and small lumps of sandy, grey or cream material is telling you that mortar has failed somewhere higher up.
On a tiled roof, mortar sits in several places, and each of them can shed it:
- The bedding beneath the ridge tiles at the apex.
- The bedding and pointing along the hips.
- The mortar at the verges, where the roof meets a gable wall.
- Pointing around the end tiles at the ends of the ridge.
- A chimney stack, where the mortar can also weather and fall.
Grit from the tiles themselves can look similar. A concrete tile can shed a little of its surface, so a pinch of sandy material alone does not prove a mortar fault. Lumps with a flat, bedded face, or pieces that look like pointing, point more clearly to a failing joint.
The why ridge tiles come loose guide covers how bedding loses its hold, which is one route for the pieces that reach the gutter, and the cracking and frost that loosen it can work on a ridge for a long while before anything drops.
What you can see without climbing
A look up at the roof from a safe place outside, aided by binoculars where available, gives a first idea of where the mortar is going. Do not climb up to check. The clues are on the skyline and along the edges of the roof.
- A ridge line that dips, or ridge tiles at uneven heights.
- Gaps, dark shadows or ragged mortar beneath the ridge tiles.
- A hip tile that has slipped or tilted.
- Crumbling edges along the gable verge, with the tiles sitting unevenly.
- Pieces of mortar on paths, patios or window sills below the gable.
More than a handful of pieces, or a gutter that keeps filling with grit after it has been cleared, suggests the source is still active. A one-off scatter after a storm may be old pointing that has finally let go. Either way, the gutter is a symptom, and the roof above is where the cause sits.
A mortar-filled gutter can also hold back rainwater and spill over the eaves, which is a separate reason to deal with it. Mortar and moss together can block an outlet quickly.
Getting the source found
Photograph the gutter contents and the roof lines from the ground, then send them for a closer look. A photo on WhatsApp to 07880 284133 can show whether the ridge, a hip or a verge is the likely source, though only a survey on the roof confirms it. Keep any larger pieces, since their shape can help.
Marley says that since the 2015 amendments to BS 5534, mortar "could no longer be relied upon as the only means of securing the roof covering". A ridge or verge held only by crumbling mortar is therefore a case where the repair has to address fixing as well as bedding. The mortar verge repairs guide covers the gable side of the job.
A gutter full of mortar needs clearing so that rain can drain, and where the gutter is out of reach, that is itself a job at height. The ridge and verge repairs hub sets out the repair routes for ridges, hips and verges, from re-pointing to a dry-fixed system.
When Daylight Roofing writes the quote, it gives one total that reflects whatever the survey finds on the roof. A bird nesting under a loose ridge changes the order of the work, because the law makes it an offence to intentionally damage or destroy a nest while it is in use or being built.

