The short answer
Soft washing a roof means applying a cleaning solution at low pressure, letting it work on the moss, lichen and algae, and then rinsing it off or leaving the weather to do so. It leaves out the force of a jet wash, and the tile maker Marley calls high powered jet washes "not recommended" for roof coverings of slate or tile.
How a soft wash is applied
The idea is to let a product do the work that force would otherwise do. A cleaning solution is sprayed or brushed onto the roof from a low-pressure line, so the liquid lands on the tiles gently rather than striking them. The solution then sits on the surface and acts on the moss, lichen and algae, which loosens their hold on the covering.
After that, the roof may be rinsed with clean water, again at low pressure, or the rinse may be left to rain over the following weeks. Which of the two applies depends on the product and the roof, and the product label says what is intended. Where growth is thick, a soft brush or hand scraping can take the bulk of it off first, so the solution has less to deal with.
No official definition fixes what the term covers. One firm may mean a gentle rinse, another a treatment that stays on the roof for weeks, and a third a brush-and-wash combination. That vagueness is the reason to ask exactly what will be applied, at what pressure and with what product.
The roof covering matters too. Concrete, clay and slate respond differently to cleaning, and the page on cleaning methods compared sets the approaches side by side.
Gentle compared with a jet
Marley, a tile maker, says "The use of high powered jet washes is not recommended as it can damage the surface of the slate or tile, thus reducing its expected life considerably". The concern is the way a jet works: a narrow, fast stream is a poor match for a tile or a slate, because the surface of the covering can be worn away along with the growth.
The two methods differ in what they ask of the roof, and the table shows the contrast without ranking the firms that use them.
| Point | Soft wash | Pressure wash |
|---|---|---|
| Force on the tile | Low | High |
| What does the work | The solution | The jet |
| Marley's advice | Not covered | Not recommended |
Low pressure is not a free pass. A solution that is too strong, left too long or used on a delicate covering can still mark the surface, and run-off still has to be dealt with. Old, worn tiles may flake under any treatment, which is a point a survey of the covering can settle before anything is applied. A tile that is already cracked will not be improved by water of any pressure, and a clean that loosens it can turn a cosmetic job into a repair. Our guide to roof cleaning and tile damage covers what a covering can and cannot take.
What to ask before it starts
Because the name is loose, the details are where the quality lives. A short list of questions gives a clear picture of what a quote involves.
- Which product is used, and what does its label say about the surface and about plants?
- Is the roof brushed or scraped first, and how?
- Is it rinsed, or left to weather, and for how long?
- Where does the run-off go, and how are the gutters dealt with?
- How is the roof reached, and does that involve scaffold?
None of these needs technical knowledge to ask, and the answers should be clear enough to write down. If they are vague, treat that as information. A clear answer on the product and the run-off is worth more than a promise about how the roof will look afterwards, because the appearance depends on the roof, the weather and the growth.
Where the answers come back clear, the quote itself should be simple to read: one written total after a survey, with the access, the method and the product described in words. For the wider picture of cleaning, treatments and costs, the roof cleaning page is the place to begin.

