Call 01582 935272

Cleaning a flat roof

Cleaning a flat roof: moss, ponding and membranes

A flat roof collects moss, silt and standing water differently from a pitched roof, and what it is covered in decides which cleaning is safe. Felt, EPDM and GRP each have limits, and so do the outlets and upstands around them.

10 minute read

Get a written quote

Call 01582 935272WhatsApp us

Yellow and grey lichen on weathered clay plain tiles
PicturedYellow and grey lichen on weathered clay plain tiles.
A roof drawing with its parts named: moss, lichen, washed tiles, gutterMossLichenWashed tilesGutter

Why a flat roof is cleaned differently

A pitched roof sheds water down a slope covered in overlapping tiles. A flat roof is a single waterproof skin, and the skin is the thing that keeps the house dry. Every cleaning decision on a flat roof comes back to protecting that skin, because a tile can be replaced one at a time while a split in a membrane lets water into the structure beneath it.

The slope is also very slight. Water leaves a flat roof slowly, so leaves, silt, seeds and dust settle on it and stay. Moss and algae need a damp place to take hold, and a roof that holds a film of water after rain is one. A garage roof under an overhanging tree, a porch roof in the shade of a wall and an extension roof that catches leaf litter are the places where growth gathers.

What the roof is covered in matters before anything else. Built-up felt, EPDM rubber and GRP, which is glass-reinforced plastic, are three different materials. Each can be scratched, lifted or softened in its own way, and a method that is safe on one can harm another. The covering is the first thing to establish, and a roofer can tell it apart on a visit where an owner may not be able to.

Access is part of the picture too. Walking a flat roof to clean it puts weight on the covering, and some coverings take that better than others. A roof that has been walked on in hard boots, dragged across with a ladder or scraped with a metal blade can leave small cuts that are invisible from the ground and show up as a stain on the ceiling months later. Flat roofs on houses are covered under flat roofing, and the cleaning questions start there.

Felt, EPDM and GRP: what each tolerates

Built-up felt is the oldest of the three, and its surface can be softened by heat or abrasion. EPDM is a single sheet of rubber, which gives it few joints, but it can be cut or punctured by a sharp edge. GRP is a rigid shell with a gel coat, which takes a brush well but can crack at movement joints and show crazing where the surface has weathered.

Lifespans are quoted by different publishers, and they do not agree. HomeBuilding gives approximate lifespans of 25-30 years for EPDM, 25-30 years for GRP and 10-15 years for felt. Less gives "EPDM rubber membrane typically lasts 30 to 50 years", "GRP fibreglass lasts 25 to 40 years with minimal maintenance" and "Torch-on felt lasts 10 to 20 years depending on quality and installation". Both sets are shown below, and neither is a promise for a given roof.

Lifespans quoted for flat roof coverings, in years
CoveringHomeBuildingLess
EPDM25-3030 to 50
GRP25-3025 to 40
Felt10-1510 to 20

The age of a covering is the second thing a cleaner has to know. A felt roof close to the limit of its range is a poor candidate for any treatment that stresses the surface, because the cleaning can expose how worn it is. In that case the better conversation is about repair or replacement, and the guide to cleaning methods compared shows which methods put the least load on a surface.

Ponding and what standing water tells you

Ponding means a film or pool of water still lying on the covering once the rain is over. It is a separate matter from moss, though the two go together, because a pool keeps the covering damp and damp is what moss and algae need. Cleaning a roof that ponds clears the growth for a while and leaves the cause where it was.

The cause is the fall. NFRC reports that BS 6229:2025 sets "a minimum 1:80 finished fall for general roof areas and internal gutters". IKO reports: "To achieve a 1:80 fall, the code of practice says that the roof should be designed for a fall of 1:40". A roof that holds water may have settled, deflected or been built with too little slope to begin with.

BS 6229:2025 is the current code, and its scope is flat roofs with continuously supported flexible waterproof coverings, so felt and EPDM fall inside it. Lead has its own detailing and sits outside it, and the 2018 edition has been withdrawn.

A pool around an outlet is a different thing from a pool in the middle of the roof. A pool by an outlet can be silt or leaves blocking the way out, which a brush and a clear outlet put right. A pool in the middle of a bay points to the deck or the fall, and only a survey of the roof can say which. Cleaning does not alter the fall. If a roof ponds after every spell of rain, the question for a roofer is whether it can be repaired, re-laid to a better fall or replaced, and that is a decision on the structure rather than the surface.

Outlets, gutters and debris

A flat roof drains through outlets, through a gutter along one edge or through a scupper in a parapet. A blocked outlet turns the whole roof into a tank. Leaves, moss that has been brushed down and the grit that washes off a roof can all end up there, and clearing them is the cleaning job that pays off on a flat roof.

Clearing is done by hand, from the roof or a safe ladder position, with the debris lifted out rather than pushed down the pipe. A drain rod down a downpipe can shift a blockage, but it can also compact it lower down where it is harder to reach. Gutters along a flat roof edge want the same treatment, and the way a gutter behaves in cold weather is covered in gutter cleaning and winter.

  • Outlets and grates: lift out leaves and silt
  • Gutters and scuppers: clear the full length, not only the end
  • Upstands and flashings where the roof meets a wall: look for lifting or gaps
  • Chippings or paving on the surface: check they have not blocked a drain

Where a flat roof has stone chippings, the stones can shift and sit in an outlet, and sweeping them back is part of the job. Where it has a green or sedum covering, the planting is a different subject altogether, and a general cleaning method does not suit it. If scaffold has to stand on the pavement to reach this roof, we arrange the licence with our scaffolder.

Moss, algae and what grows on a flat roof

Moss on a flat roof sits in the thin layer of silt that settles on the surface, and it is more visible on a rough covering such as a mineral-finished felt than on a smooth rubber or GRP face. Algae shows as green or black staining and can form wherever water lingers. Lichen is a slower, crusty growth that clings to the surface and is harder to shift. The three are described one by one in the guide to moss, lichen and algae on roofs.

Growth does not always harm a membrane directly. What it does is keep the surface wet and hold silt against it, and a root that works into a worn seam or a blistered patch can open a path for water. A roof with a sound surface and a little growth may need a light clean, while a roof with growth over cracks and lifted laps needs repair first.

A flat roof is also a place where a biocide treatment needs thought. Some products are made for tiles and are not intended for felt or rubber, and the label says what a product may be used on. The runoff from a flat roof goes straight to one outlet, which concentrates it, so the question of where that outlet leads matters more here than on a pitched roof. The guide to biocide roof treatments sets out what to ask.

Cleaned roofs do get re-covered with growth, since the conditions that grew it have not gone. Shade, a trapped film of water and leaf fall from nearby trees all return. A cleaner who says growth will not come back has made a promise the roof cannot back up.

Methods that suit a membrane

Gentle methods suit membranes. A soft brush, a low-pressure rinse and hand lifting of silt and debris are the ordinary tools. A hard jet of water is the one to be careful of, because seams and laps are the weak points of a membrane and a hard jet loads them. A metal scraper or a wire brush can score the covering and is the wrong tool for any of the three.

Chemicals need a check on the label too. Some cleaning products soften bitumen or attack the adhesives that hold a membrane together, and the product label should say what coverings it is made for. If it does not mention flat roof membranes, that is a reason to ask before it goes on the roof.

Walking on the roof is a risk of its own. Boards laid across the surface spread the load, soft-soled footwear protects the covering and tools are lifted rather than dragged. A flat roof over a garage, shed or outbuilding built or refurbished before 2000 needs a further check, because HSE's advice is: "If the building was built or refurbished before 2000, assume that there is asbestos in it." HSE also says "AC roofs are always fragile", and a fragile roof is not walked on.

A method that works well on a roof of one covering is no guide to another, and a quote that names the method and the covering together is easier to judge than one that says only "flat roof clean". The wider comparison of methods, with the risks listed against each, is in the methods guide.

When cleaning is not the answer

Some flat roofs are past cleaning. Blisters, splits, open laps, lifting at an upstand and a deck that gives underfoot are signs of a covering that has stopped working as a waterproof skin. Cleaning such a roof makes it look better and hides the defect, and the next heavy rain gets through it. Moss growing in a crack is a symptom, and the crack is the problem.

Repairing a section or replacing the covering turns on the proportion of sound membrane, its age and the deck beneath. One written total follows a survey that takes in the surface, the perimeter and the drainage. Repair and replacement choices for a flat roof sit under flat roofing.

A new membrane brings the energy rules into play. Approved Document L treats a replaced waterproof layer as renovation, so a full recovering is discussed against that standard rather than as a simple swap. Replacing the whole covering also goes past the Planning Portal's "Less than 50 per cent of the roof is affected" limit, so Building Regulations approval comes into the plan.

Photos of the surface, the outlets and any ceiling stain can go to our WhatsApp line for a first look. They cannot replace a survey, though they do show whether the roof is a cleaning job or a membrane that has run its course. The rest of the cleaning work is gathered under roof cleaning.

Flat roof cleaning, answered plainly

01Can a flat roof be pressure washed?

A hard jet puts load on the seams and laps that hold a membrane together, so a brush and a low-pressure rinse suit these coverings better. Which method is safe depends on the covering and its age. A roof near the end of its life may not stand any cleaning, and the quote should say what method will be used on it.

02Why does my flat roof keep holding water after rain?

Water left lying after rain points to a fall problem or a blocked outlet. NFRC reports that BS 6229:2025 sets "a minimum 1:80 finished fall for general roof areas and internal gutters" for membrane roofs. Silt or leaves can explain a pool at an outlet, while a pool mid-bay points to the deck. A survey tells the two apart.

03Will moss damage a felt, EPDM or GRP roof?

Moss keeps a surface wet and holds silt against it, and a root can work into a worn seam or a blister. A sound covering with a little growth may need only a light clean, and a covering with growth over cracks needs repair. The growth is a sign of damp conditions, so look at why the roof stays wet as well as at the moss itself.

04Is it safe to walk on my flat roof to clean it?

Walking spreads weight over a covering that can be cut or crushed, and boards and soft-soled footwear lower the risk. A roof on a building built or refurbished before 2000 needs a check first, since HSE's line is to assume asbestos and to treat AC roofs as always fragile. A fragile roof is never walked on, and a ladder on a wet surface adds a second risk.

05Should I clean a flat roof or replace it?

It depends on the state of the covering. Blisters, splits, open laps, lifted upstands and a soft deck mean the roof has stopped working as a waterproof skin, and cleaning would hide the problem. A sound covering with surface growth is a cleaning job. The age of the roof, how much of it is in good condition and what lies beneath it settle the choice, and a survey comes first.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote