Call 01582 935272

Roof replacement

Can you change from concrete to clay tiles?

Swapping concrete tiles for clay is possible on a roof that passes three tests: the pitch must suit the new tile, the structure must take its weight and the planning position must allow it.

Get a written quote

Call 01582 935272WhatsApp us

Cracked mortar bedding under the ridge of a concrete tile roof
PicturedCracked mortar bedding under the ridge of a concrete tile roof.

The short answer

Yes, a concrete tile roof can be re-covered in clay when the pitch suits the chosen tile, the roof structure can carry the new covering and the planning position allows it. A covering 15 per cent or more heavier than the old one needs Building Regulations approval, and a structural check comes before the work.

A roof drawing with its parts named: ridge, even courses, verge, eavesRidgeEven coursesVergeEaves

Does the roof's pitch suit the tile

Each tile has a lowest slope it can be laid on, and that limit is set product by product, not by the material alone. On Marley's published list a clay Ashdowne needs 35 degrees while a clay Lincoln pantile needs only 15, so two clay roofs can sit twenty degrees apart in what they will accept. The concrete range spreads out in the same way. The table gives six of Marley's published figures. The names are products, not places.

Minimum pitch for six Marley tiles
TileMaterialMinimum pitch
AshdowneClay35°
HawkinsClay30°
Lincoln pantileClay15°
PlainConcrete35°
EdgemereConcrete17.5°
AngliaConcrete25°

What this means in practice is that the angle of your existing roof narrows the choice before taste does. A shallow roof that carries a pantile today may be too flat for a clay plain tile. A tape-and-angle measure on site gives the real figure, and the maker's own table says whether the tile you have in mind can be laid at it. Where the angle rules a tile out, another clay tile, or a different covering altogether, may fit. The roof covering options page sets the alternatives side by side.

Will the structure take the weight

The Planning Portal says Building Regulations approval applies where the new covering material "increases the weight of the roof covering by 15 per cent or more", and it advises checking with a structural engineer or surveyor before any work starts on site. Approved Document A sets its line at a roof loading "increased by more than 15%". Under either wording, the two coverings are weighed against each other, using the makers' own data sheets, and that comparison decides whether the structure needs a closer look.

Nothing in the rules says which way the weight moves. Tiles vary by product within clay and within concrete, so the only safe way to find out is to put the real figures for the old and new tile side by side, never to assume one material is the lighter. A full re-roof needs approval in any case, because it affects more than 50 per cent of the roof, and the guide to new roof Building Regulations and Part L covers the wider picture.

Fixing matters as well. Tile clips and nails follow a site-specific fixing specification under BS 5534, which allows for how exposed the roof is. A different tile can also have a different batten gauge and lap, so battens and underlay may have to change to suit it.

What the planning position adds

Re-roofing a house is normally permitted development under Class C of the permitted development rules. Two things can alter the picture. An Article 4 direction takes away permitted development rights within a mapped area, and listed status brings listed building consent for work that affects the building's character. Flats have no householder permitted development rights at all. Central Bedfordshire Council's page notes that permitted development rights are stricter for properties in conservation areas, so it is sensible to put your address to the council and get its answer in writing before you commit to a tile.

Our own part is to check the planning or building-control route with the council before the work is booked in. The planning permission guide explains what Class C does and does not cover, and the roof replacement page describes the full job from survey to finished roof.

Looks and lifespan are worth weighing too. HomeBuilding gives approximate lifespans of 60-80 years for clay tiles and 40-50 years for plain concrete tiles. Marley reports that the BRE determined a minimum life expectancy of 60 years for clay roof tiles. These come from outside publishers and are no assurance for your own roof. What a swap costs is settled after the survey, and it comes as a single written total, with the tile you choose and the access to the roof setting the figure.

Concrete to clay, answered plainly

01Can clay tiles go straight onto the old battens?

Do not count on it. A different tile can call for a different batten gauge, lap and fixing pattern, so the battens, the underlay and the clips are checked against the new tile's instructions, and replaced where they do not suit. The survey looks at the timber beneath the old tiles, and the written price covers the roof as it is found.

02Does a conservation area stop a change of tile?

A conservation area does not remove Class C, the rule that covers re-roofing. An Article 4 direction can, and what a direction covers depends on that council's own list, so put your street to the council and ask whether one applies. Listed buildings keep Class C but need listed building consent for anything affecting their character. Ask before you choose a tile.

03Which lasts longer, clay or concrete?

Published figures differ. HomeBuilding's approximate lifespans are 60-80 years for clay tiles and 40-50 years for plain concrete tiles. Marley says that typically, roof tiles are expected to last for around 60 years, and adds that this is not a guarantee or warranty of its longevity. Underlay, battens, fixings and workmanship all play a part, so no figure is a promise.

04Can a photo of my tiles tell you what will fit?

A photo is a start, and a roofer can look at one sent to 07880 284133 on WhatsApp. It cannot show the pitch or the state of the timbers, which come from the survey. The written price therefore follows the survey, and a swap to clay is only confirmed once the roof has been measured and the weight comparison has been made.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote