The short answer
Yes, modern slating is laid over an underlay fixed to the rafters, with battens above it and the slates on those. The underlay catches wind-blown rain and condensation that the slates let past. The type matters: high-resistance and low-resistance underlays call for different ventilation in a cold roof.
What underlay does under slates
From the rafters upwards, a pitched slate roof is built in layers. The underlay is laid over the rafters, battens are fixed through it, and the slates are hung from the battens. Slates shed water by overlap, but a gap in a lap, a cracked slate or driven rain can let some past, and the underlay is the second line that carries it down to the gutter. Without it, the battens and the slates are the only barrier, and that leaves little margin when wind drives rain upward under a lap.
It also deals with moisture from inside. Warm, damp air from the house can reach the cold side of the roof, where it may condense on cold surfaces, and the underlay and the ventilation around it are part of how that is managed. The 2021 edition of BS 5250, the standard on managing moisture in buildings, is the one in force.
The slates themselves are fixed under BS 5534:2014+A2:2018. Marley says installing to BS 5534 "isn't required by law", yet a roof built to it carries known fixing and lap details. The layers work together, so a good underlay under poor slating, or the other way round, leaves a weak point somewhere in the roof, and that weak point is what the survey looks for.
Underlay resistance and what it means for air
Underlays are grouped by how freely water vapour passes through them. An HR underlay (high resistance) stops vapour passing, so air in the roof space needs another route out. A low-resistance underlay, written LR, lets more vapour through. Which of the two is chosen sets what ventilation the roof needs, and it is a decision taken with the covering and the ceiling in mind.
| Roof build | Ventilation named |
|---|---|
| Cold roof, HR underlay, pitch of 15° or less | 25 mm along the eaves |
| Cold roof, HR underlay, pitch above 15° | 10 mm along the eaves |
| LR underlay, well-sealed ceiling, air-permeable covering | 3 mm normal eaves construction, with UKAS third-party certification |
Marley's wording for the last row is that "fortuitous ventilation at the eaves via normal eaves construction (3mm) is all that is required, provided the requirements of UKAS Third Party certification are fully met." The first two rows apply to a cold roof with HR underlay. Every condition in a row has to be met together, which is why the underlay, the ceiling and the covering are all checked against the data for the exact products before a specification is settled.
Older slate roofs and what a survey checks
Not every slate roof was built to today's practice. An older roof may have been laid with no underlay at all, or with a felt that has since dried out, torn or slipped. Such a roof can have kept the rain out for years because the slates were sound, and the underlay's absence only shows when slates slip or a gap opens. Torn or slipped felt can sit unseen for years above a sound-looking ceiling.
When an old covering is lifted for re-slating or repair, the opportunity to fit proper underlay arrives with it. The rafters are visible, battens can be renewed where they have rotted, and the ventilation is set to suit the underlay chosen. The guide to slate roofs and Building Regulations explains where approval applies to the work.
Looking over the roof includes the underlay wherever it shows, at the eaves and from inside the loft, and the signs of trouble beneath the slates. Condensation on the rafters, daylight between laps, stained boards and a damp smell can all point to a failed underlay or poor ventilation. Our slate roofing page describes the work, and a photograph sent to 07880 284133 on WhatsApp is a first step toward a view.

