Call 01582 935272

Slate roofing

What is the minimum pitch for a slate roof?

Slate sheds rain by gravity, so the slope matters. Below a certain angle, water can creep under the overlaps instead of running off, and slate becomes the wrong covering.

Get a written quote

Call 01582 935272WhatsApp us

A slipped slate and a rusted nail on a natural slate roof Close-up of a natural blue-grey slate roof with one slate slipped out of its course and a rusted nail head visible, moss in the joints
PicturedA slipped slate and a rusted nail on a natural slate roof Close-up of a natural blue-grey slate roof with one slate slipped out of its course and a rusted nail head visible, moss in the joints.

The short answer

With a 500 mm slate, a 115 mm overlap and moderate exposure, the lowest pitch BS 5534 indicates for natural slate is 20 degrees, as Cupa reports it. Roofs fixed with hooks need a steeper slope, 25 degrees or above. A shallower or more exposed roof needs a different specification, or another covering altogether.

A roof drawing with its parts named: slates, slipped slate, tingle, battensSlatesSlipped slateTingleBattens

The 20 degree figure and where it comes from

Pitch means how steeply a roof slope rises, in degrees above the horizontal. A flat roof sits near zero, while a steep gable can reach 45 degrees or more, and a hipped roof can have slopes of different angles on the same house. Slate depends on that angle because its slates are not sealed to each other. Rain must run off the foot of each slate quickly enough that none creeps back under the overlap.

Cupa, a slate maker, reports that BS 5534 "also indicates that the minimum roof pitch for natural slate is 20 degrees in the case of a project situated in an area with moderate exposure and with a slate 500mm long and a 115mm overlap". The conditions travel as a set: angle, exposure, slate length and overlap. Alter any one and the minimum may move with it.

Slate pitch limits reported by Cupa
CaseMinimum pitch
Natural slate, moderate exposure, 500 mm slate, 115 mm overlap20 degrees
Roof fixed with hooksNot below 25 degrees

The code in question is BS 5534:2014+A2:2018, which BSI lists as current. The wider slate roofing page sets it beside the other standards for the covering.

What can push a roof above the minimum

That 20 degrees belongs to one example. It does not promise that every slate laid at 20 degrees keeps the weather out. A site more exposed than moderate, or a shorter slate, may call for a steeper slope or a deeper overlap. The overlap itself is explained in headlap on a slate roof.

The fixing method adds a limit of its own. Cupa advises against hooks on any slope under 25 degrees, a higher floor than the figure for the slate. A roof sitting between 20 and 25 degrees is therefore nailed instead. The two methods are set side by side in slate hooks.

Exposure is a judgement made at the site, house by house. The fixing specification for any tile or slate roof is drawn up to suit how exposed that site is, and it takes precedence over the general minimums in the code. A house on open ground and a house between neighbours can be given different answers, even at the same pitch and with the same slate. The same applies to a roof set among taller buildings and a roof tucked into a valley between wings of the same building; each is judged where it stands, and the minimum in the code is a starting point for that judgement and no more than that.

If the pitch is too low for slate

Some roofs fall short of what slate needs. A rear extension, a porch roof or a dormer cheek can sit at a low angle, and a slate covering there would invite leaks. The answer is to use another covering on that slope, such as a membrane or a sheet metal, and keep slate for the steeper parts of the house.

Other coverings carry minimum pitches of their own. Marley, for example, publishes a figure for each tile it makes, from 15 degrees for its Lincoln clay pantile to 35 degrees for its Ashdowne clay tile. Those are product figures from one maker and have no bearing on slate, but they show the lowest workable angle changes from one covering to the next.

An existing roof has its angle measured at the survey, because a slope that looks steep from the pavement can be shallower than it seems. Where a slate roof leaks and its angle sits close to the limit, the angle itself may be the cause, and no patch will cure that. After the survey you get one price in writing, and it names the covering proposed for each slope.

Slate pitch, answered with figures

01Can slate go on a roof at 15 degrees?

Not on the strength of the figures Cupa publishes, whose BS 5534 example gives 20 degrees for natural slate at moderate exposure. A roof at 15 degrees falls below that, so slate would need a different specification or the slope would need a different covering. The survey measures the real angle, which is where any answer for your roof begins.

02Why is the limit for hooks higher than for slate?

Cupa gives 25 degrees as the floor for hook fixings, against 20 degrees for the slate in its example. For an owner, the effect is that a roof sitting between those two angles is nailed and not hooked. The headlap and the exposure of the site still apply on top of either figure, so neither number settles the specification alone.

03How can I check the angle of my own slope?

A roofer reads it with a level on the slope, or from a drawing of the gable end, and the survey takes that reading as a matter of course. Judging it from the ground is unreliable, because a roof looks steeper from below than it is. If you hold plans for an extension, a copy sent to 07880 284133 on WhatsApp may show the angle.

04Does a shallow slate roof change the planning position?

Re-roofing a house comes under Class C of permitted development, and changing to another covering follows the same rules, though a conservation area, a listed building or an Article 4 direction can alter that. Details are in the planning guide. For your own address, the planning team at your council can say whether anything special applies, and it is better to ask before the work starts, whatever slope the roof has.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote