Call 01582 935272

Winter and wet weather

Slating in winter and wet weather

Slating in winter is possible on the right day, and a poor day is a reason to wait. Part of our slate roofing pages.

9 minute read

Get a written quote

Call 01582 935272WhatsApp us

Rainwater running off a slate roof into a cast iron gutter
PicturedRainwater running off a slate roof into a cast iron gutter.
A roof drawing with its parts named: slates, slipped slate, tingle, battensSlatesSlipped slateTingleBattens

Can slate be laid in winter?

The main covering of a slate roof is fixed with nails or hooks. It is not stuck down and it is not left to cure. That changes the winter question. It is not whether a bond will set in the cold; it is whether the day lets the roof be worked on safely and the slates be fixed to the specification the roof calls for.

Winter bears on several parts of the job instead. Wind acts on slates that are not yet fixed and on slopes that have been stripped. Wet and frosted surfaces make footing unsafe. A few materials carry limits published by their makers, mortar and sealants among them. Each has its own section below.

None of this makes slating a summer-only trade, and none of it can be settled by the calendar. The decision is taken on the roof, on the day, against the weather. A roofer who declines to work on a given day is following the same logic as the fixing standards. Marley's guidance says BS 5534 minimums "will always be superseded by the generation of a Fixing Specification, which is site specific". The specification stays the same in winter; the conditions around it are what change.

Winter factors on a slate job
FactorWhat it bears onWhat decides
WindLoose slates, open slopes, ridge workThe day on the roof
Wet or frostFooting and handlingWhether the surface is safe
ColdMortar and sealantThe maker's data sheet

Wind and slates not yet fixed

A slate is thin and flat, and a slope open to the sky catches the wind. Slates stacked on a roof, loose battens and sheets of boarding can be lifted by a gust and dropped onto whatever lies below. Work at height stops in strong wind in any season, and winter simply brings more days on which that call has to be made.

Once the slates are fixed, the covering relies on its fixings. BS 5534 sets minimums, and Marley's guidance says a site-specific Fixing Specification supersedes them. The specification is worked out for how exposed the particular roof is. That is why two houses on the same road may not end up with the same fixings.

Ridge and hip tiles need separate thought. Marley's guidance has them fixed mechanically in all cases, against the uplift that wind is calculated to produce. It also notes that since the 2015 amendments mortar "could no longer be relied upon as the only means of securing the roof covering". A ridge left half finished when work stops for the day is where a roof gives the wind most to work with.

  • whether slates and boards stacked on the roof are secured against a gust
  • whether the open slope can be made weathertight before the day ends
  • whether ridge and hip fixings are in place or only part done
  • whether the person on the roof can stand and move safely

Frost and wet slate underfoot

A wet slate is slippery, and a frosted one more so. A roof that cannot be stood on safely cannot be worked on, and no schedule alters that. Whether a slate roof can be walked on at all is the subject of our guide on walking on a slate roof.

For a homeowner the advice is simple: stay off a roof that is wet or frosted. A pair of binoculars from the garden, or a phone picture from an upstairs window, shows a slipped slate or a gap in the ridge without any risk. WhatsApp on 07880 284133 takes the picture, and it can be looked at without anyone going up.

Ice in the gutters is a related winter problem. A frozen gutter or outlet leaves melt water with nowhere to go, and water that backs up can run beneath the lowest slates at the eaves. Leave the ice to thaw. A scraper or a hammer can chip a slate edge or crack a gutter.

A gutter that stays full after a thaw may be blocked, or it may have lost its fall. Brett Martin gives 1 mm of fall for every 600 mm of run to the outlet, and a gutter still full once the ice has gone is worth a look, from the ground and not from a ladder in wet weather.

Mortar and sealant in cold weather

Not everything on a slate roof is fixed mechanically. Mortar is used to bed some ridge, hip and verge details and to point around them, and sealants close small gaps. These are the materials that carry working limits. Fresh mortar that freezes before it has set can be damaged, and a sealant needs a clean, dry surface to grip. Both facts come from ordinary building practice, and the maker's data sheet sets the limit for each product.

A mortar-bedded ridge also depends on what holds the tiles besides the mortar. A mortar-bedded ridge carries mechanical fixings as well, in line with the Marley guidance quoted above.

Dry-fixed systems are the alternative where a mortar bed is not wanted. BS 8612:2018 covers ridge, hip and verge units that go on without a mortar bed, fixed dry, and BSI lists it as current. The survey and the fixing specification decide which approach suits a roof, not the time of year.

Cold-weather limits on small details
DetailWinter concernWhat sets the limit
Mortar bedSetting in cold or wetThe maker's data sheet
SealantNeeds a clean, dry surfaceThe maker's stated limits
Dry-fixed ridgeNo mortar to setBS 8612:2018 and the fixing specification

Stripped slopes and temporary cover

A re-slate has a point of weakness. Once the old slates come off, the underlay and battens are all that stand between the weather and the loft. Rain on an open slope reaches the ceilings, and wind can lift loose underlay. That is why a stripped slope has to be made weathertight before the work stops, with sheeting fixed down firmly, because sheeting that flaps will let the rain under it.

A temporary repair is a stopgap and not a cure. A patch, a sheet or a dab of sealant can hold off water for a spell, but the underlying fault is still there. A slipped slate may have slipped because of a failing fixing, and the guide to slate roof problems sets out the faults a roof can develop.

If water is coming in, a bucket under the drip and furniture and electrical items moved clear is the first step. Do not go onto the roof to fit cover yourself in wet or icy weather. Take photographs of the stain indoors and of the slope from outside, and pass them on through WhatsApp so the roof can be looked at.

  • catch the drip and move anything electrical out of its path
  • photograph the stain inside and the roof from the ground
  • keep clear of a wet, frosted or windy roof
  • treat any temporary cover as a pause, not the repair

After a storm: photographs and insurance

Storm damage sits where roofing meets insurance. The Financial Ombudsman Service gives its view of what a storm is: "a storm usually involves violent winds, usually with rain, hail or snow", and it adds that "Rain, hail or snowfall by itself can constitute a storm". Whether a given event counts is a matter between the owner and the insurer, and the policy wording is what the insurer applies. Once damage has been covered over for the time being, the roof still needs its own assessment, and a photograph of the cover in place helps show what was done.

The Financial Ombudsman Service says it will usually look at expert reports and photos. So before anything is tidied or shifted, take photographs: the slope from the ground, any stain or wet patch inside, and whatever has been damaged. Then contact the insurer. Receipts for stopgap protection are worth holding on to, and so is a note of the date the damage was found.

On cost, MyJobQuote's page, last updated 22 October 2026, reads: "Emergency roofer call-out costs typically range from £150 to £300, while extensive storm damage repairs can cost £1,200 or more." These figures cover roofing in general and are not specific to slate. Our own price is one written total, given after a survey of the roof.

Waiting or acting: choosing the winter job

Sorting the work by urgency makes the winter decision easier. A roof letting water in, or a slate slipping loose over a path or a door, is a job that cannot wait for better weather. A cracked slate that lets nothing through may be a job to plan for a drier spell, with a photograph or a survey to confirm which it is.

Slate is a long-lived covering, which takes some of the pressure off. HomeBuilding, on a page last updated 30 September 2025, gives approximate lifespans of 100+ years for Welsh slate, 75-100 years for Spanish natural slate and 50-80 years for reclaimed Welsh slate. Age alone does not show condition, but a roof with that kind of range has little to gain from work rushed into a bad week.

The rules do not change with the weather. A job that goes past the Planning Portal's limits needs Building Regulations approval in January as it does in July, and the energy figures, planning classes and conservation area questions are the same all year. Our guide to slate roofs and Building Regulations sets them out.

A survey of the roof precedes any quote, and what was found, along with what else was spotted, is put plainly. A photograph sent to WhatsApp on 07880 284133 is a good place to start when the weather rules out a visit.

Questions on winter slating

01Is it safe to slate a roof in winter?

It depends on the day. Slates are fixed with nails or hooks, so cold alone does not stop the covering being fixed. Wind, wet slate and frost decide whether a roofer can work safely and fix to the specification for the roof. A roofer who waits for a better day is applying the same logic as the fixing standards, which are set for the site and its exposure.

02Why does wind matter so much on a slate roof?

A slate is thin and flat, and slates stacked on a roof, loose battens and boards can be lifted by a gust. Fixings are calculated for the site's exposure under a site-specific specification, and Marley has ridge and hip tiles fixed mechanically in all cases. A ridge that is only part done when work stops for the day is the weak point, because the wind has less to push against on a finished one.

03Can a ridge be bedded in mortar in cold weather?

That depends on the mortar's data sheet, which sets the working limits, since fresh mortar that freezes before it has set can be damaged. Marley's guidance has mechanical fixings go in as well, so the mortar is never the only thing holding a tile in place on a ridge or hip. For roofs where a mortar bed is not wanted, BS 8612:2018 covers ridge, hip and verge units that are fixed dry.

04Should I climb up to look for storm damage?

No. A wet or frosted slate roof is slippery, and the risk is not worth the view. Use binoculars at ground level, or an upstairs window, photograph what you can see, then pass the pictures to WhatsApp on 07880 284133. Photographs also help with an insurance claim, because the Financial Ombudsman Service says it will usually look at expert reports and photos.

05Does home insurance cover storm damage to slates?

Cover for storm damage depends on the policy wording, and the insurer gives the first answer. The Financial Ombudsman Service says "a storm usually involves violent winds, usually with rain, hail or snow", and that "Rain, hail or snowfall by itself can constitute a storm". Photograph first and move things afterwards, then tell the insurer, and keep receipts for temporary protection. For most complaints, a business has up to 8 weeks to consider a complaint.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote