The short answer
A leaking warehouse roof is repaired by finding where water enters, which may be some distance from the drip, and fixing that point: a lap, fixing, gutter, rooflight or damaged covering. A temporary seal may come first, with the lasting repair following once the cause and the roof's safety are clear.
Tracing the entry point before any repair
Water on a warehouse floor tells you roughly which area is affected, and little more. On a profiled sheet roof or a flat membrane roof, rain can run along a purlin, down a sheet rib or across a lining before any drip appears, so the wet patch below may sit several metres from the actual opening. Repairing the spot above the puddle can leave the real fault untouched, and the leak returns with the next shower.
A roofer works from both sides. Inside, the survey follows stains, rust runs and wet insulation back along the structure. On the roof, it looks at the covering around those lines: sheet laps, fixings, flashings, gutter joints, outlets and the edges of rooflights. On a flat roof it also looks for standing water, since a roof that holds puddles can leak at a seam that would otherwise stay dry. Moss, debris and blocked outlets are checked for the same reason, because they hold water against the covering.
A controlled test, where water is run over one section at a time, can confirm a suspected route. It is slower than a visual check and is kept for leaks that resist the simpler approach. Thermal imaging and moisture meters can also help to map wet insulation under a membrane.
Repairs by type of roof covering
The repair follows the covering. The points below describe what each type of roof can involve.
- Profiled metal sheets: re-sealing or re-fixing laps, replacing fixings with failed washers, and patching or replacing a corroded sheet.
- Asbestos cement sheets: no repair should start until the material is identified, and HSE says that "AC roofs are always fragile".
- Single-ply membranes: re-welding or re-bonding a seam, and renewing the detail around a pipe or upstand.
- Built-up felt: cutting out a blister or split and patching, or overlaying the old layer once repairs stop holding.
- Gutters and outlets: clearing, re-jointing or replacing a section, and checking the fall towards the outlet.
- Rooflights: renewing the sealant or the unit, with the surrounding covering checked as well.
Our guide to cut-edge corrosion explains why the cut edges of coated steel sheets can fail from the edge inwards. Where leaks return at the same sheets, a patch may not be the right answer, and the signs of commercial roof failure help show whether the whole covering is wearing out. Edge details such as ridge flashings, verge trims and parapet copings also deserve a close look, since they are joints in the structure as well as in the covering.
Safe access, temporary cover and the written price
Getting onto a warehouse roof safely comes before any repair. A rooflight or an old cement sheet may not carry a person's weight, so crawling boards, edge protection and clear walkways are set up first. For buildings of that age, HSE's advice is "If the building was built or refurbished before 2000, assume that there is asbestos in it." Sheets are therefore not cut or drilled until the material has been identified.
If rain is coming in, a temporary seal can keep stock dry while the real fault is dealt with. A sheet, a sealant bead or a patch buys time and no more, and it should be followed by a proper repair rather than left to face another winter. Wind can lift a loose sheet, and a patch laid over dirt or moisture may let go.
Photos by WhatsApp to 07880 284133 are a good way in, and calls go to 01582 935272. A leak cannot be priced from the floor; after the roof survey, the quote is one total in writing. For the wider range of work, see the commercial roofing page.

