The short answer
A roof valley is the dip where two sloping roof planes meet at an inward corner, forming a channel that carries rainwater from both slopes down to the gutter. Valleys can be lined with lead, glass-reinforced plastic or formed with tiles. Because the water of two slopes concentrates there, cracked linings and blockages can lead to leaks.
What a valley does on the roof
Where a roof has an L shape, a T shape, an extension or a dormer, two slopes meet at an internal corner instead of an outward one. That corner is a valley. It works as a gully set into the roof, collecting the rain from the slope on either side and sending it down to the gutter in one stream. A hip is the opposite, since it stands proud as an outward joint, and a ridge is the high point where slopes meet at the top.
Because the water from two roof planes funnels into one line, a valley takes a heavier flow than a plain slope does. Leaves, moss and silt can collect in the channel, and a blockage can send water sideways under the tiles. The edges of the tiles beside the valley are cut at an angle to follow it, so the covering and the lining have to work together.
There are three forms to know. A lead valley has a sheet of lead dressed along the channel with the tiles lapped over its edges. A GRP valley uses a moulded glass-reinforced plastic trough in the same position. A tiled valley, sometimes called a swept or laced valley, uses specially shaped tiles and no visible channel. The pitched roof problems guide places valleys among the other places a pitched roof can fail.
The three types and signs of failure
| Type | What it is | What to look for |
|---|---|---|
| Lead | Rolled lead sheet dressed along the channel | Cracks, splits or creep along the sheet |
| GRP | A moulded plastic trough | Cracks, a faded surface or a loose edge |
| Tiled | Cut tiles swept round the corner | Slipped or broken tiles along the line |
Rolled lead sheet is made to BS EN 12588 in codes 3 to 8. Code 4, for example, is 1.80 mm thick, and the job's specification sets the code chosen for each detail. For weights, only the makers' own charts count, such as Calder and Ecobat, and the two give slightly different weights for codes 3 and 6.
From inside the house, a brown mark on the ceiling or on an angled wall beneath a valley is a sign something has let water through. From the garden, binoculars may show moss, leaves or a dark line along the channel, a tile that has slipped at the edge, or lead that is lifted or split. Please do not step onto the roof to look, because a valley is a narrow, steep and slippery place to put weight.
A fault along a valley can get worse during rain, so photograph it, note the date and look at the loft below. The lead roofing and leadwork pages cover lead details in general.
Repair, renewal and what it costs
A small fault, such as a cracked patch or a tile slipped beside the valley, may be dealt with in place. A lining that is split in several places or worn along its length can point to renewal, with the tiles either side lifted so the new lining can be laid properly beneath them. Which route a valley needs is settled by looking at it from above, with the tiles and the lining both in view.
No third-party source gives a price for valley work as such. MyJobQuote's lead figures are for chimney leadwork alone and do not carry over to valleys, so any figure quoted for a valley is set by its length, its type and how easily it can be reached. Replacing the whole covering of a roof is a larger job, and a re-roof past the 50% limit needs Building Regulations approval, as the re-tiling and building regulations guide explains.
Daylight Roofing prices from the survey, and what you receive is one total, put in writing. A photo of the valley and the ceiling stain beneath it can be sent to 07880 284133 on WhatsApp first. The range of work is gathered under pitched roofing.

