Call 01582 935272

Pitched roofing

Why are my roof tiles slipping?

Tiles slip down a roof when whatever holds them has let go: a nail that has worked loose, a batten that has rotted away, or a nib that has broken. The tile itself is only the symptom.

Get a written quote

Call 01582 935272WhatsApp us

A freshly repointed brick chimney with new lead flashing and flaunching on a clay tile roof
PicturedA freshly repointed brick chimney with new lead flashing and flaunching on a clay tile roof.

The short answer

Roof tiles slip when their fixing has failed. A nail can fatigue and work loose, a batten can rot and stop holding the nail, and the nib that hangs a tile on its batten can break. Wind then shifts the loose tile, so stay off the roof, take a picture of the gap from below and ask for a survey.

A roof drawing with its parts named: ridge, even courses, verge, eavesRidgeEven coursesVergeEaves

What lets a tile slip

A roof tile hangs from a batten by a nib on its upper edge, and in many coverings it is also held by a nail or clip. When it slips, one of those holds has failed, or the support behind it has. The cause matters, because a slipped tile can be a one-off fault or the first visible sign of something more widespread.

  • Nail fatigue: a nail can corrode or work loose in its hole as the timber around it swells and dries, so the tile it held shifts.
  • Rotten battens: timber that has stayed wet can soften, and a soft batten stops gripping nails and nibs.
  • Broken nibs: a tile's hanging nib can crack, and frost damage is one way that can happen to a tile that has held water.
  • Movement: wind, the weight of a person on the roof or a branch can shift a tile that was already marginal.

Each of these "can" happen, and none is a certainty on any one roof. A loose nail points to the fixing, while a run of slipped tiles in the same area points to a batten problem underneath. Lifting the tiles is the only way to see which it is. The roof battens answer explains the laths in the middle of that diagnosis.

What to do from the ground

Keep off the roof. A slipped tile is loose by definition, and the tiles around it may be too. Any walking on the covering can break more of it, and the slope is a poor place to stand. Binoculars from the garden are enough for a first look.

Take pictures of the gap or the displaced tile from several angles, and note the date. If the damage followed a storm, that record helps with an insurer. Look from inside as well. A torch from the loft hatch may show daylight through the gap, a damp patch on the underlay or timber, or a bedroom ceiling stain below. Move anything stored under the gap out of the way.

Move children, pets and any parked car clear of the spot under a tile that looks ready to fall. A tile hanging by its last fixing can come down without warning. A temporary fix from a ladder is not worth the risk, because it can leave the tile no more secure than before.

A photograph sent to 07880 284133 on WhatsApp makes a sensible first step, and the survey that follows settles whether the problem is a single tile or the fixing system behind it. The pitched roof problems guide lists the other faults that can look similar from below.

Repair routes and what they cost

If the batten and the other tiles are sound, a single slipped tile can be refixed or replaced, with a new nail or clip. If a batten has rotted, the tiles over it come off, the batten is renewed and the tiles go back. Where the problem runs across a large area, re-tiling is the route, and a full re-roof is covered by the re-tiling and building regulations guide.

Published ranges from other bodies give a feel for the scale. Which? Trusted Traders, in a survey of 11 traders in November 2025 on prices that exclude VAT, gave £75 to £400 for replacing one to six broken or missing standard roof tiles. MyJobQuote's page of 6 October 2026 gives around £215 as the average for replacing roof tiles. Those are the sources' figures, not our prices.

Where the cause is the batten, the job is larger than the tile and the figures above no longer apply. Daylight Roofing writes a single total once the survey has found the cause. A slipped tile left alone can let rain reach the timbers beneath it, so a prompt photo is worth sending. The wider range is under pitched roofing.

Slipping tiles, asked plainly

01Should a single slipped tile worry me?

Not by itself, though it should be looked at promptly, and a loose tile can be dangerous to anyone below it. A gap lets water get to the sheet and timbers below, and the tile may be close to falling. Keep clear of the ground below, photograph it from a safe place and send the picture over. If water is already coming through the ceiling, mention that when you send the picture.

02Why did my tiles slip after a storm?

Wind can shift a tile that was already loose, so a storm can show up a fixing that had been failing for a while. The cause may still be a fatigued nail or a soft batten and not the storm alone, which is why the fixing is checked even after bad weather. Take pictures of the damage first, before anything is moved, and let your insurer know, since they may ask to see them.

03Can I push a slipped tile back myself?

It is not worth the risk. Reaching a tile means a ladder against gutters or a scaffold, and stepping onto the covering can break more tiles. A tile pushed back without a fixing can slip again in the next gust. Photograph it from the ground and ask for a survey instead of trying a repair yourself, even if the tile looks easy to reach.

04Is there any way to spot rotten battens?

Nobody can be certain from outside. A sagging slope, several slipped tiles in one patch or damp timber seen from the loft all point towards it. Only lifting the tiles shows the battens themselves. A torch from the hatch, kept on the joists, is the safest way to look at the underside, and a photo of what it shows can be sent over.

Get a written price for your roof

10-year workmanship guarantee, in writing

Tell us about your roof

Call WhatsApp Written quote