The short answer
Not normally. Re-roofing a house in slate, or in any other covering, is normally permitted development under Class C, so no planning application is needed. Listed status, an Article 4 direction and flats work differently, and Building Regulations approval is a separate matter with tests of its own.
Where re-slating sits in the planning rules
Householder permitted development comes from Part 1 of Schedule 2 to the General Permitted Development Order 2015. Within it, Class C carries the heading "Any other alteration to the roof of a dwellinghouse", and the Government's technical guidance describes it as covering "re-roofing or the installation of roof lights/windows". Stripping a slate roof and laying new slate, or another covering, falls inside that heading.
Permitted development means national rules already grant the permission, so the council is not asked for it. Class C does attach conditions of its own, among them limits that run from the original roof, and the planning permission for roof work guide sets those out in full. Here the point is simpler: swapping the covering of a house is an alteration that Class C was written for.
Class C has no article 2(3) exclusion. A home in a conservation area, or in a National Landscape such as the Chilterns, is therefore still free to be re-covered under it, and only a dormer or other roof enlargement is pulled out of permitted development on that land. That distinction gets muddled, so it is worth keeping straight when someone says a protected area rules out a new roof.
Four cases where the answer shifts
The default is clear enough, and four circumstances are worth checking before work is booked.
- The home is a flat or maisonette. The order defines a dwellinghouse so as to leave out a building containing flats, so householder rights are not available.
- The home is listed. Classes B and C remain, but listed building consent comes into play for work done "in any manner which would affect its character as a building of special architectural or historic interest".
- An Article 4 direction covers the road. GOV.UK describes it as a way to "withdraw specified permitted development rights across a defined area", and the council can say whether yours is one.
- The job includes a dormer or other roof enlargement, which is a Class B matter and not part of re-slating.
A listed home or a protected street is also where the choice of slate can interest the council. If you are weighing natural slate against another covering on such a roof, put the question about materials to the planning team before anything is ordered, and keep a note of what it says. Colour, size and the way the slates are laid are all points the council may raise.
The other approval that may be needed
Freedom from planning rules does not remove Building Regulations, which run on separate tests. The Planning Portal sets two limits: an application is "normally" unnecessary only while less than 25 per cent of the building envelope and less than 50 per cent of the roof is affected. Taking a whole slate roof off and replacing it exceeds that second limit, so it falls outside the exception, and an application is needed.
The Planning Portal's main page on re-roofing states: "In most situations, this work will need Building Regulations approval." A covering whose weight rises by 15 per cent or more also needs approval, and the advice is to have a structural engineer or surveyor examine the roof beforehand, since the rafters carry the extra load. The guide to slate roofs and Building Regulations covers both points.
Building control means the council's building control team or a registered building control approver. Before any work starts, we take the planning and building-control route up with the council for your address. Our slate roofing page lists the re-slating work we do. A planning answer and a building control answer are given separately, so each one is asked for. Ask each office for its answer in writing.

